Clock (CLK) Jitter and Phase Noise Conversion - AN3359
ثبت نشده
چکیده
Period Jitter Period jitter (JPER) is the time difference between a measured cycle period and the ideal cycle period. Due to its random nature, this jitter can be measured peak-to-peak or by Root of Mean Square (RMS). We begin by defining the clock rising-edge crossing point at the threshold VTH as TPER(n), where n is the time domain index, as shown in Figure 1. Mathematically, we can describe JPER as:
منابع مشابه
Clock Jitter Estimation and Suppression in OFDM Systems Employing Bandpass Σ∆ ADC
In this paper, we analyze the effect of clock jitter on the performance of OFDM-based systems applying digital IF architecture. A bandpass Σ∆ ADC is used for the analog to digital conversion process. An accurate and realistic model of the clock jitter in bandpass Σ∆ ADC is implemented. Results from this paper show that clock jitter severely degrades OFDM system performance by introducing both p...
متن کاملJitter Measurements for CLK Generators or Synthesizers - Application Note - Maxim
Clock (CLK) generators and synthesizers form the pulse of a complex digital system and errors in a clock's signal quality can have wide-ranging effect. One of the most important performance measurements is clock jitter. Jitter is defined as "the short-term variation of a signal with respect to its ideal position in time." In a clock generator chip, there are many factors which contribute to out...
متن کاملJitter Measurements for CLK Generators or Synthesizers - AN2744
Clock (CLK) generators and synthesizers form the pulse of a complex digital system and errors in a clock's signal quality can have wide-ranging effect. One of the most important performance measurements is clock jitter. Jitter is defined as "the short-term variation of a signal with respect to its ideal position in time." In a clock generator chip, there are many factors which contribute to out...
متن کاملModeling of Jitter Characteristics for the Second Order Bang-Bang CDR
Bang-Bang clock and data recovery (BBCDR) circuits are hard nonlinear systems due to the nonlinearity introduced by the binary phase detector (BPD). The specification of the CDR frequency response is determined by jitter tolerance and jitter transfer. In this paper, jitter transfer and jitter tolerance of the second-order BBCDR are characterized by formulating the time domain waveforms. As a re...
متن کاملAnalysis and mitigation of phase noise and sampling jitter in OFDM radio receivers
This article addresses the analysis and digital signal processing (DSP)-based mitigation of phase noise and sampling clock jitter in orthogonal frequency division multiplexing (OFDM) radios. In the phase noise studies, the basic direct-conversion receiver architecture case is assumed with noisy downconverting oscillator. In the sampling jitter case, on the other hand, the so-called direct-radio...
متن کامل