Experimental and modeling study on effects of N2 and CO2 on ignition characteristics of methane/air mixture

نویسندگان

  • Wen Zeng
  • Hongan Ma
  • Yuntao Liang
  • Erjiang Hu
چکیده

The ignition delay times of methane/air mixture diluted by N2 and CO2 were experimentally measured in a chemical shock tube. The experiments were performed over the temperature range of 1300-2100 K, pressure range of 0.1-1.0 MPa, equivalence ratio range of 0.5-2.0 and for the dilution coefficients of 0%, 20% and 50%. The results suggest that a linear relationship exists between the reciprocal of temperature and the logarithm of the ignition delay times. Meanwhile, with ignition temperature and pressure increasing, the measured ignition delay times of methane/air mixture are decreasing. Furthermore, an increase in the dilution coefficient of N2 or CO2 results in increasing ignition delays and the inhibition effect of CO2 on methane/air mixture ignition is stronger than that of N2. Simulated ignition delays of methane/air mixture using three kinetic models were compared to the experimental data. Results show that GRI_3.0 mechanism gives the best prediction on ignition delays of methane/air mixture and it was selected to identify the effects of N2 and CO2 on ignition delays and the key elementary reactions in the ignition chemistry of methane/air mixture. Comparisons of the calculated ignition delays with the experimental data of methane/air mixture diluted by N2 and CO2 show excellent agreement, and sensitivity coefficients of chain branching reactions which promote mixture ignition decrease with increasing dilution coefficient of N2 or CO2.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Ignition enhancement by addition of NO and NO2 from a N2/O2 plasma torch in a supersonic flow

The effects of NO and NO2 produced by using a plasma jet (PJ) of a N2/O2 mixture on ignition of hydrogen, methane, and ethylene in a supersonic airflow were experimentally and numerically investigated. Numerical analysis of ignition delay time showed that the addition of a small amount of NO or NO2 drastically reduced ignition delay times of hydrogen and hydrocarbon fuels at a relatively low in...

متن کامل

Effect of Hydrogen Addition to Natural Gas on Homogeneous Charge Compression Ignition Combustion Engines Performance and Emissions Using a Thermodynamic Simulation

The HCCI combustion process is initiated due to auto-ignition of fuel/air mixture which is dominated by chemical kinetics and therefore fuel composition has a significant effect on engine operation and a detailed reaction mechanism is essential to analysis HCCI combustion. A single zone-model permits to have a detailed chemical kinetics modeling for practical fuels. In this study a single-zone ...

متن کامل

Modeling and Comparison of Optimized Isotherm Models for H2, N2, CO, CH4 and CO2 Adsorption Using Cuckoo Search Optimization Algorithm

In this study, modeling of hydrogen, nitrogen, carbon monoxide, methane and carbon dioxide sorption on UTSA-16 framework extrudates in the pressure swing adsorption process was carried out. The pure gas adsorption of these gases at the pressure range (0 to 80) bars at (298, 313, and 338) K have also been measured in a fixed bed. Langmuir, Toth, Sips, UNILAN, Virial and Dubinin-Astakhov adsorpti...

متن کامل

Experimental Study on the Explosion of Gasoline-air Mixture in Reduced-scale Storage Tank

Fire and explosion accidents often occur in storage tanks leading to great economic loss and serious casualties during the working, operation and maintenance. This paper established a reduced-scale storage tank experimental system, and then the explosion characteristics of gasoline-air mixture in storage tank were studied. The experimental results show that several parameters (such as concentra...

متن کامل

The effects of added hydrogen to the premixed of methane and air in a MEMS channel

In this paper, the effect of adding hydrogen to the composition of methane and air in a micro combustor is investigated by a three-dimensional numerical method. First, the results of the current study in determining the wall temperature of the micro combustion chamber are compared with those obtained from the experimental and numerical results of the previous research. By confirming the numeric...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 6  شماره 

صفحات  -

تاریخ انتشار 2015