Modelling of a Power System in a Combined Cycle Power Plant

Simulators for power plants can be used for many different purposes, like training for operators or for adjusting control systems, where the main objective is to perform a realistic behaviour for different operating conditions of the power plant. Due to an increased amount of variable energy sources in the power system, the role of the operators has become more important. It can therefore be very valuable for the operators to try different operating conditions like island operation. The aim of this thesis is to model the power system of a general combined-cycle power plant simulator. The model should contain certain components and have a realistic behaviour but on the same time be simple enough to perform simulations in real time. The main requirements are to simulate cold start, normal operation, trip of generator, a controlled changeover to island operation and then resynchronisation. The modelling and simulations are executed in the modelling software Dymola, version 6.1. The interface for the simulator is built in the program LabView, but that is beyond the scope of this thesis. The results show a reasonable performance of the power system with most of the objectives fulfilled. The simulator is able to perform a start-up, normal load changes, trip of a generator, changeover to island operation as well as resynchronisation of the power plant to the external power grid. However, the results from the changing-over to island operation, as well as large load losses during island operation, show an unreasonable behaviour of the system regarding the voltage magnitude at that point. This is probably due to limitations in calculation capacity of Dymola, and the problem has been left to further improvements due to lack of time. There has also been a problem during the development of a variable speed regulated induction motor and it has not been possible to make it work due to lack of enough knowledge about how Dymola is performing the calculations. Also this problem has been left to further improvements due to lack of time. Nomenclature Symbols Symbol Description Value Unit δ Load angle [rad] E Resulting emf [V] E f Field voltage [V] f Frequency [Hz] H Inertia constant [s] J Moment of inertia [kg*m 2 ] K D Damping factor [1] n Turning ratio [1] n s Synchronous speed [rpm] p Number of pole pairs [1] P Active power [W] π Pi 3.14159265 [1] Q Reactive power [VAr] R Frequency …