Analyses of shielding benchmark experiments using FENDL-3 cross-section data starter library for ITER and IFMIF applications
نویسندگان
چکیده
Recently IAEA has been conducting a coordinated research project to update the FENDL-2.1 nuclear data library to FENDL-3. In the present study, FENDL-3, Starter Library, Release 4 (FENDL-3/SLIB4) has been extensively tested through analysis of many fusion relevant benchmark problems. FENDL-3/SLIB4 gives better results for the FNG ITER shielding benchmark and the tungsten benchmark experiments than the previous FENDL-2.1. As for the shielding benchmark in the neutron energy range above 20 MeV, the TIARA transmission experiments through iron and concrete using p-Li quasi-monoenergetic neutron source have been analyzed. FENDL-3/SLIB4 provides satisfactory results for the TIARA shielding benchmark through iron. For concrete, however, some discrepancy was found. The present analysis suggests importance of 16 O data in the neutron energy range above 20 MeV for shielding calculations through concrete.
منابع مشابه
UWFDM-1361 Benchmarking FENDL-2.1 with Impact of ENDF/B-VII.0 Release on Nuclear Heating and Damage
MCNP calculations for a calculational benchmark representative of an early ITER design were carried out to investigate the impact of ENDF/B-VII.0 release on FENDL-2.1. The results presented in this work clearly show that the previously observed differences in nuclear heating and radiation damage are removed when the correctly processed ENDF/BVII.0 data are used. Differences in all nuclear param...
متن کاملIntegral experiment of induced radioactivity in D-T fusion neutron environment and validation of activation cross section library
Under ITER/EDA R&D Task T-218, an integral experiment on the induced radioactivity was conducted at the Fusion Neutronics Source (FNS) facility in JAERI. The objective was to provide experimental data for validating the inventory calculation codes and relevant activation cross section libraries to be used in the ITER nuclear design. Sample materials investigated were Al, Mg, Ti, V, Mn, Fe, Ni, ...
متن کاملBenchmark experiment on bulk shield of SS316/water with simulated superconducting magnet
A bulk shielding experiment was performed at the D-T neutron source FNS, using the assembly simulating shield blanket, vacuum vessel and toroidal field coil (superconducting magnet) of ITER. The objective was to investigate the influence on nuclear parameters due to the nuclei involved in the toroidal field coil and the effect of B4C/Pb. The analysis was performed by MCNP4-A and the DOT3.5 (P5S...
متن کاملApplication of IRDF2002 dosimetry data to shielding benchmarks using the Monte Carlo code MCBEND
The IRDF2002 dosimetry cross-section data are processed into very fine energy groups and added to the detector response library for the Monte Carlo code MCBEND. The IRDF2002 covariances are processed into broad groups to form a MCBEND detector covariance library. A number of benchmark experiments are analysed using MCBEND with both IRDF2002 and IRDF90 data and the results compared. Uncertaintie...
متن کاملNuclear heating measurements for SS-316, copper, graphite, tungsten, chromium, beryllium in a copper centered assembly bombarded with 14 MeV neutrons and analysis
Under ITER/EDA R&D Task T-218, an experiment on nuclear heating was conducted at the Fusion Neutronics Source Facility (FNS) in JAERI in order to provide experimental data of nuclear heating for structural materials and to validate the data and methods relevant to ITER design calculations. Probe materials, SS-316, Cu, W, Zr, Be, Cr and graphite were tested in a copper centered experimental asse...
متن کامل