Taguchi analysis of delamination associated with various drill bits in drilling of composite material
نویسنده
چکیده
This paper presents a prediction and evaluation of delamination factor in use of twist drill, candle stick drill and saw drill. The approach is based on Taguchi’s method and the analysis of variance (ANOVA). An ultrasonic C-Scan to examine the delamination of carbon fiber-reinforced plastic (CFRP) laminate is used in this paper. The experiments were conducted to study the delamination factor under various cutting conditions. The experimental results indicate that the feed rate and the drill diameter are recognized to make the most significant contribution to the overall performance. The objective was to establish a correlation between feed rate, spindle speed and drill diameter with the induced delamination in a CFRP laminate. The correlation was obtained by multi-variable linear regression and compared with the experimental results. # 2004 Elsevier Ltd. All rights reserved.
منابع مشابه
Optimization on Delamination of Cutting Parameter during Drilling on Gfrp Plastics Based on Taguchi Method
Drilling of glass fibre reinforced plastic (GFRP) composite is different from metallic materials due to its mechanical properties. The drilling of this material may generate delamination of drilled holes on workpiece. The purpose of this paper is to investigate the influence of the cutting parameters, such as cutting speed and feed rate, point angle of drill and material thickness on delaminati...
متن کاملComprehensive analysis of delamination in drilling of composite materials with various drill bits
Beside the twist drill, the effects of various drill geometries were rarely discussed in analytical fashion. This study presents a comprehensive analysis of delamination in use of various drill types, such as saw drill, candle stick drill, core drill and step drill. In this analysis, the critical thrust force at the onset of delamination is predicted and compared with the twist drill. © 2003 El...
متن کاملEffects of special drill bits on drilling-induced delamination of composite materials
Drilling is the most frequently employed operation of secondary machining for fiber-reinforced materials owing to the need for joining structures. Delamination is among the serious concerns during drilling. Practical experience proves the advantage of using such special drills as saw drill, candle stick drill, core drill and step drill. The experimental investigation described in this paper exa...
متن کاملOptimization of Drilling Parameters on Delamination Based on Taguchi Method in Drilling of Natural Fiber Reinforced (Agave) Composite
Agave is the one of the abundantly available plant in India. The wide application of agave reinforced composite plate necessitate the joining of two plates together. For making such joint drilling of those plates is required. Drilling of natural fiber composites is different from the other metals because of its mechanical properties. The major problem faced in drilling of theses natural fiber c...
متن کاملThe effect of chisel length and associated pilot hole on delamination when drilling composite materials
Drilling-induced delamination often occurs both at the entrance and the exit of the workpiece during drilling of composite material. Investigators have studied analytically and experimentally that delamination in drilling can be correlated to the thrust force of the drill. With a pre-drilled pilot hole, the delamination can be reduced significantly. Early reference reported models of drilling-i...
متن کامل