A Multi-beam and Multi-range Radar with Fmcw and Digital Beam Forming for Automo- Tive Applications
نویسنده
چکیده
In this paper, we propose a multi-beam and multi-range (MBMR) radar with frequency modulated continuous wave (FMCW) waveform and digital beam forming (DBF) algorithm to cover a detection area of long range and narrow angle (150 m, ±10◦) as well as short range and wide angle (60 m, ±30◦) as a single 24 GHz sensor. The developed radar is highly integrated with multiple phased-array antennas, a two-channel transmitter and a four-channel receiver using K-band GaAs RF ICs, and back-end processing board with subspacebased DBF algorithm. The proposed 24GHz MBMR radar can be used for an adaptive cruise control (ACC) stop-and-go system which typically consists of three radars, such as two 24 GHz short-range radars for object detection in an adjacent lane and one 77 GHz longrange radar for object detection in the center lane.
منابع مشابه
The UMRR-S: A High-Performance 24GHz Multi Mode Automo- tive Radar Sensor for Comfort and Safety Applications
The paper describes the UMRR-S sensor, which has been developed for automotive applications in a co-operation between Volkswagen AG and smart microwave sensors GmbH as a derivative of the UMRR platform. The sensor is able to operate in the 24GHz ISM band and is applicable for Advanced Driver Assistance System functions. It can run both in UWB Pulseand in a number of Narrowband FMCW Modes. It ca...
متن کاملDesign and Implementation of Digital Demodulator for Frequency Modulated CW Radar (RESEARCH NOTE)
Radar Signal Processing has been an interesting area of research for realization of programmable digital signal processor using VLSI design techniques. Digital Signal Processing (DSP) algorithms have been an integral design methodology for implementation of high speed application specific real-time systems especially for high resolution radar. CORDIC algorithm, in recent times, is turned out to...
متن کاملReconfigurable Digital multiple beam forming with planar phased array RADAR on FPGA
Beam forming is a signal processing technique used in antenna arrays for directional signal transmission or reception. Phased array radar is very important in modern radar development, and multiple digital beams forming technology is the most significant technology in phased array radar. Digital multiple beam forming on each antenna element about large phased array radar is impossible in proces...
متن کاملHigh Dynamic Range Antenna and RF-Subsystem For FMCW Imaging Radar K.Solbach* and M.Böck**
The presentation discusses the requirements on the characteristics of antenna and RFsubsystem of a FMCW Imaging Radar with respect to the dynamic range and presents the design of an advanced demonstrator. The discussion is based on experience with the HiVision-Radar system /1/ which observes the ground from an elevated position (e.g. airborne platform, see also /2/) and employs a frequency scan...
متن کاملPerformance of Multi-beam Satellite Systems With A New Bandwidth Sharing Algorithm
An efficient resource allocation is important to guarantee the best performance with a fair distribution of multi-beam satellite capacity to provide satellite multimedia and broadcasting services. In this way, available bandwidth and capacity problems in new satellite system likes Multi-Input-Multi-Output (MIMO), exploring new techniques for enhancing spectral efficiency in satellite communicat...
متن کامل