GGA+U description of lithium intercalation into anatase TiO2

نویسندگان

  • Benjamin J. Morgan
  • Graeme W. Watson
چکیده

We have used density-functional theory generalized gradient approximation GGA to study lithium intercalation at low concentration into anatase TiO2. To describe the defect states produced by Li doping a Hubbard “+U” correction is applied to the Ti d states GGA+U . Uncorrected GGA calculations predict LixTiO2 to be metallic with the excess charge distributed over all Ti sites, whereas GGA+U predicts a defect state 0.96 eV below the conduction band, in agreement with experimental photoelectron spectra. This occupied defect state corresponds to charge strongly localized at a single Ti 3d site neighboring the intercalated lithium with a magnetization of 1 B. This polaronic state produces a redshifted optical absorption spectrum, which is compared to those for the native O-vacancy and Ti-interstitial defects. The strong localization of charge at a single Ti center lowers the symmetry of the interstitial geometry relative to that predicted by GGA. The intercalated lithium sits close to the center of the octahedral site, occupying a single potential energy minimum with respect to displacement along the 001 direction. This challenges the previous interpretation of neutron diffraction data that there exist two potential energy minima separated by 1.6 Å along the 001 direction within each octahedron. Nudged elastic band calculations give barriers to interoctahedral diffusion of 0.6 eV, in good agreement with experimental data. These barrier heights are found to depend only weakly on the position of the donated electron. The intercalation energy is 2.14 eV with GGA and 1.88 eV with GGA+U, compared to the experimental value of 1.9 eV. Li-electron binding energies have also been calculated. The Lii -TiTi complex has a binding energy of 56 meV, and a second electron is predicted to be bound to give Lii -2TiTi with a stabilization energy of 30 meV, indicating that intercalated lithium will weakly trap excess electrons produced during photoillumination or introduced by additional n-type doping.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Li intercalation effects on magnetism in undoped and Co-doped anatase TiO2

The effects of n-type carrier doping by Li intercalation on magnetism in undoped and Co-doped anatase TiO2 are investigated. We have found that doped n-type carriers in TiO2 are localized mainly at Ti sites near the intercalated Li. With increasing the intercalation, local spins are realized at Ti. In the case of Co-doped TiO2, most of the added n-type carriers fill the Co 3d bands and the rest...

متن کامل

In situ visualization of Li-ion intercalation and formation of the solid electrolyte interphase on TiO2 based paste electrodes using scanning electrochemical microscopy.

Scanning electrochemical microscopy (SECM) inside a glove box was used for the in situ visualization of solid electrolyte interphase (SEI) formation as well as Li-ion intercalation and de-intercalation on anatase TiO2 based paste electrodes.

متن کامل

Electrodeposition of Ag nanoparticles onto bamboo-type TiO2 nanotube arrays to improve their lithium-ion intercalation performance

Bamboo-type TiO2 nanotube arrays prepared via anodic oxidation are modified with Ag nanoparticles by pulsed electrochemical deposition, for improved lithium-ion intercalation property as the anode material in lithium-ion batteries. Heat treatment converts as-formed nanotubes into anatase for Ag deposition. Bare and Ag-modified nanotubes are cycled at a current density of 800 μAcm between 1.0 an...

متن کامل

Water Multilayers on TiO2 (101) Anatase Surface: Assessment of a DFTB-Based Method

A water/(101) anatase TiO2 interface has been investigated with the DFT-based self-consistent-charge density functional tight-binding theory (SCC-DFTB). By comparison of the computed structural, energetic, and dynamical properties with standard DFT-GGA and experimental data, we assess the accuracy of SCC-DFTB for this prototypical solid-liquid interface. We tested different available SCC-DFTB p...

متن کامل

TiO2 nanotube arrays annealed in CO exhibiting high performance for lithium ion intercalation

Anatase titania nanotube arrays were fabricated by means of anodization of Ti foil and annealed at 400 ◦C in respective CO and N2 gases for 3 h. Electrochemical impendence spectroscopy study showed that CO annealed arrays possessed a noticeably lower charge-transfer resistance as compared with arrays annealed in N2 gas under otherwise the same conditions. TiO2 nanotube arrays annealed in CO pos...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2010