Design of a current Mode Sample and Hold Circuit at sampling rate of 150 MS/s
نویسندگان
چکیده
A current mode sample and hold circuit is presented in this paper at 180nm technology. The major concerns of VLSI are area, power, delay and speed. Hence, we have used a MOSFET in triode region in the proposed architecture for voltage to current conversion instead of a resistor being used in previously proposed circuit. The proposed circuit achieves high sampling frequency and with more accuracy than the previous one. The performance of the proposed circuit is depicted in the form of simulation results.
منابع مشابه
High-speed Low-Power Integrating CMOS Sample-and-Hold Amplifier Architecture
A novel “current-mode ” Jumpling architecture for sample-andhold ( S b H ) ampli$ers results in a substantial reduction in error due to sampling clock jitter and aperture time. These reduced errors make possible a substantial reduction in power over a conventional “voltage-mode ” S b H with the same sample rate. In order to demonstrate the pegormance of this architecture, a S&H with 4 subsample...
متن کاملA Current-Mode Single-Resistance-Controlled Oscillator Employing VDCC and All Grounded Passive Elements
Realization of a novel single-resistance-controlled oscillator, employing an active element and all grounded passive elements, is the purpose of this manuscript. With requirements for completing the design being only a single Voltage Differencing Current Conveyor and four grounded passive components, it is also a preferable choice for integrated circuit implementation. The designed circuit has ...
متن کاملA 1.5V,100MS/s,12-bit Current-Mode CMOSS ample-and-Hold Circuit
A high-linearity and high-speed current-mode sampleand-hold circuit is designed and simulated using a 0.25μm CMOS technology. This circuit design is based on low voltage and it utilizes a fully differential circuit. Due to the use of only two switches the switch related noise has been reduced. Signal dependent -error is completely eliminated by a new zero voltage switching technique. The circui...
متن کاملDesign of a Sub-1.5 V, 20 MHz, 0.1% MOS Current-Mode Sample-and-Hold Circuit
This paper describes an MOS current-mode sample-and-hold (S/H) circuit that potentially operates with a sub-1.5 V supply voltage, 20 MHz clock frequency, and less than 0.1% linearity. A newly developed voltage-to-current converter suppresses the voltage change at an input terminal and achieves low-voltage operation with superior linearity. Sample switches are differentially placed at the inputs...
متن کاملA Current-Mode Circuit With a Linearized Input V/I Conversion Scheme and the Realization of a 2-V/2.5-V Operational, 100-MS/s, MOS SHA
This paper proposes a circuit to linearize the signal current and improve the distortion characteristics at the input of a current-mode circuit. Input voltage-to-current (V/I) conversion is carried out by a resistor that connects the signal source and the current input terminal of the current-mode circuit. The signal current flowing into the current-mode circuit through this resistor is distort...
متن کامل