RFC 4311 IPv 6 Host - to - Router Load Sharing
نویسنده
چکیده
In the conceptual sending algorithm in [ND] and in the optional extension in [ROUTERSEL], a next hop is chosen when no destination cache entry exists for an off-link destination or when communication through an existing router is failing. Normally, a router is selected the first time traffic is sent to a specific destination IP address. Subsequent traffic to the same destination address continues to use the same router unless there is some reason to change to a different router (e.g., a redirect message is received, or the router is found to be unreachable).
منابع مشابه
RFC 6106 IPv 6 RA DNS Options November 2010
This document specifies IPv6 Router Advertisement options to allow IPv6 routers to advertise a list of DNS recursive server addresses and a DNS Search List to IPv6 hosts.
متن کاملRFC 5006 IPv 6 RA Option
Status of This Memo This memo defines an Experimental Protocol for the Internet community. It does not specify an Internet standard of any kind. Discussion and suggestions for improvement are requested. Distribution of this memo is unlimited. Abstract This document specifies a new IPv6 Router Advertisement option to allow IPv6 routers to advertise DNS recursive server addresses to IPv6 hosts.
متن کاملRFC 2185 Routing Aspects Of IPv 6 Transition September 1997
This document gives an overview of the routing aspects of the IPv6 transition. It is based on the protocols defined in the document "Transition Mechanisms for IPv6 Hosts and Routers" [1]. Readers should be familiar with the transition mechanisms before reading this document. The proposals contained in this document are based on the work of the Ngtrans working group.
متن کاملRFC 6666 IPv 6 Discard Prefix
Remote triggered black hole filtering describes a method of mitigating the effects of denial-of-service attacks by selectively discarding traffic based on source or destination address. Remote triggered black hole routing describes a method of selectively rerouting traffic into a sinkhole router (for further analysis) based on destination address. This document updates the "IPv6 Special Purpose...
متن کاملILMI-Based Server Discovery for ATMARP
Presently, configuring a host or router to use ATMARP [1] is cumbersome and error-prone since it requires at least one ATM address to be statically configured on each host or router in the network. Further, it is impossible to implement a diskless host to use ATMARP since local configuration is required. ILMI-based Server Discovery, hereafter referred to as "server discovery," provides a soluti...
متن کامل