Euler3d Validation with the BACT Aeroelastic Test Case
نویسنده
چکیده
منابع مشابه
Robust Multivariable Flutter Suppression for the Benchmark Active Control Technology (BACT) Wind-Tunnel Model
The Benchmark Active Controls Technology (BACT) project is part of NASA Langley Research Center’s Benchmark Models Program for studying transonic aeroelastic phenomena. In January of 1996 the BACT wind-tunnel model was used to successfully demonstrate the application of robust multivariable control design methods (H∞ and μ-synthesis) to flutter suppression. This paper addresses the design and e...
متن کاملDevelopment of Unsteady Aerodynamic and Aeroelastic Reduced-order Models Using the Fun3d Code
Recent significant improvements to the development of CFD-based unsteady aerodynamic reduced-order models (ROMs) are implemented into the FUN3D unstructured flow solver. These improvements include the simultaneous excitation of the structural modes of the CFD-based unsteady aerodynamic system via a single CFD solution, minimization of the error between the full CFD and the ROM unsteady aerodyna...
متن کاملModeling the Benchmark Active Control Technology Wind- Tunnel Model for Application to Flutter Suppression
This paper describes the formulation of a model of the dynamic behavior of the Benchmark Active Controls Technology (BACT) wind-tunnel model for application to design and analysis of flutter suppression controllers. The model is formed by combining the equations of motion for the BACT wind-tunnel model with actuator models and a model of wind-tunnel turbulence. The primary focus of this paper i...
متن کاملLoading Estimation of Flapping Wings under Aeroelastic Effect Using Finite Element Method
The aim of this paper is to provide an aeroelastic computational tool which determines the induced wing loads during flapping flight. For this purpose, a Finite Element (FE) code based on a four-node plate bending element formulation is developed to simulate the aeroelastic behavior of flapping wings in low incompressible flow. A quasi-steady aerodynamic model is incorporated into the aeroelast...
متن کاملAiaa 99-3301-cp an Elasticity-based Mesh Scheme Applied to the Computation of Unsteady Three-dimensional Spoiler and Aeroelastic Problems
This paper presents a modification of the spring analogy scheme which uses axial linear spring stiffness with selective spring stiffeningkelaxation. An alternate approach to solving the geometric conservation law is taken which eliminates the need for storage of metric Jacobians at previous time steps. Efficiency and verification are illustrated with several unsteady 2-D airfoil Euler computati...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2001