An Experimental Study on the Measurement of Fuel to Air Ratio Using Flame Chemiluminescence
نویسندگان
چکیده
Abstract—This study is aiming at establishing the relationship between the optical signal of flame and an equivalent ratio of flame. In this experiment, flame optical signal in a furnace is measured using photodiode. The combustion system is composed of metal fiber burner and vertical furnace, and flame chemiluminescence is measured at various experimental conditions. In this study, the flame chemiluminescence of laminar premixed flame is measured using commercially available photodiode. It is experimentally investigated the relationship between equivalent ratio and photodiode signal. In addition, the strategy of combustion control method is proposed using the optical signal and fuel pressure. The results showed that certain relationship between optical data of photodiode and equivalence ratio exists, and this leads to the successful application of this system for instantaneous measurement of equivalence ration of the combustion system.
منابع مشابه
Experimental data regarding the characterization of the flame behavior near lean blowout in a non-premixed liquid fuel burner
The article presents the data related to the flame acquisitions in a liquid-fuel gas turbine derived burner operating in non-premixed mode under three different equivalence fuel/air ratio, which corresponds to a richer, an intermediate, and an ultra-lean condition, near lean blowout (LBO). The data were collected with two high speed visualization systems which acquired in the visible (VIS) and ...
متن کاملOn the Dependence of Soot Formation and Combustion on Swirling Combustion Furnaces: Measurement and Simulation
Soot concentration distribution is investigated both numerically and experimentally in methane-air diffusion flame. The experimental work is conducted with a cylindrical swirl stabilized combustor. Filter paper technique is used to measure soot volume fraction inside the combustor. The numerical simulation is based on the solution of the fully-coupled conservation equations for swirling turbule...
متن کاملAn Investigation of Fuel Mixing and Reaction in a CH4/Syngas/Air Premixed Impinging Flame with Varied H2/CO Proportion
For industrial applications, we propose a concept of clean and efficient combustion through burning syngas on an impinging burner. We performed experimental measurements of particle image velocimetry, OH radical (OH*) chemiluminescence, flame temperature, and CO emission to examine the fuel mixing and reaction of premixed impinging flames of CH4/syngas/air with H2/CO in varied proportions. The ...
متن کاملAir-Fuel Ratio Control of a Lean Burn SI Engine Using Fuzzy Self Tuning Method
Reducing the exhaust emissions of an spark ignition engine by means of engine modifications requires consideration of the effects of these modifications on the variations of crankshaft torque and the engine roughness respectively. Only if the roughness does not exceed a certain level the vehicle do not begin to surge. This paper presents a method for controlling the air-fuel ratio for a lean bu...
متن کاملAmmonia–methane combustion in tangential swirl burners for gas turbine power generation
Ammonia has been proposed as a potential energy storage medium in the transition towards a lowcarbon economy. This paper details experimental results and numerical calculations obtained to progress towards optimisation of fuel injection and fluidic stabilisation in swirl burners with ammonia as the primary fuel. A generic tangential swirl burner has been employed to determine flame stability an...
متن کامل