Full custom design of a three-stage amplifier with 5500MHz·pF/mW Performance in 0.18 mum CMO S
نویسندگان
چکیده
A full custom design of a three-stage amplifier is described in this paper. A feedback transconductance stage and a feedforward stage combined with two Miller compensation capacitors are used for frequency compensation. The circuit is designed in 0.18μm CMOS process with a 1.8V supply voltage. When driving a 150pF capacitive load, the amplifier achieves over 100dB dc gain, 2.24MHz gainbandwidth product (GBW), 62° phase margin (PM), 1.2V/μs slew rate (SR) and 61μW power dissipation. Compared to conventional multistage amplifiers, this work provides improvement in both GBW and SR, and also shows a significant improvement in MHz·pF/mW performance.
منابع مشابه
Effective Design of a 3×4 Two Dimensional Distributed Amplifier Based on Gate Line Considerations
In this paper two dimensional wave propagation is used for power combining in drain nodes of a distributed amplifier (DA). The proposed two dimensional DA uses an electrical funnel to add the currents of drain nodes. The proposed structure is modified due to gate lines considerations. Total gain improvement is achieved by engineering the characteristic impedance of gate lines and also make appr...
متن کاملImproving Linearity of CMOS Variable-gain Amplifier Using Third-order Intermodulation Cancellation Mechanism and Intermodulation Distortion Sinking Techniques
This paper presents an improved linearity variable-gain amplifier (VGA) in 0.18-µm CMOS technology. The linearity improvement is resulted from employing a new combinational technique, which utilizes third-order-intermodulation (IM3) cancellation mechanism using second-order-intermodulation (IM2) injection, and intermodulation distortion (IMD) sinking techniques. The proposed VGA gain cell co...
متن کاملA New Ultra-Wideband Low Noise Amplifier With Continuous Gain Control
This paper presents a new variable gain low noise amplifier (VG-LNA) for ultra-wideband (UWB) applications. The proposed VG-LNA uses a common-source (CS) with a shunt-shunt active feedback as an input stage to realize input matching and partial noise cancelling. An output stage consists of a gain-boosted CS cascode and a gain control circuit that moves the high resonant frequency to higher freq...
متن کاملA 10-GHz 15-dB four-stage distributed amplifier in 0.18 µm CMOS process
This paper presents a four-stage CMOS distributed amplifier (DA) design implemented in standard 0.18 μm CMOS technology. The proposed design eliminates the need for transmission line capacitors and, consequently, uses significantly smaller spiral inductors compared with the previous designs. Using the minimum size inductor, the bandwidth of the amplifiers is extended, and the quality factors of...
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کامل