Finite-dimensional piezoelectric transducer modeling for guided wave based structural health monitoring

Among the various schemes being considered for structural health monitoring (SHM), guided wave (GW) testing in particular has shown great promise. While GW testing using hand-held transducers for non-destructive evaluation (NDE) is a well established technology, GW testing for SHM using surface-bonded/embedded piezoelectric wafer transducers (piezos) is relatively in its formative years. Little effort has been made towards a precise characterization of GW excitation using piezos and often the various parameters involved are chosen without mathematical foundation. In this work, a formulation for modeling the transient GW field excited using arbitrary shaped surface-bonded piezos in isotropic plates based on the 3D linear elasticity equations is presented. This is then used for the specific cases of rectangular and ring-shaped actuators, which are most commonly used in GW SHM. Equations for the output voltage response of surface-bonded piezo-sensors in GW fields are derived and optimization of the actuator/sensor dimensions is done based on these. Finally, numerical and experimental results establishing the validity of these models are discussed. (Some figures in this article are in colour only in the electronic version)