Tactile Sensors and Other Distributed Sensors with Minimal Wiring Complexity
نویسنده
چکیده
This paper describes a tactile sensor design, allowing data acquisition from a sensor array using a single wire. The sensor is implemented as a filter. Sensor excitation changes filter characteristics, and the pressure profile can be recovered from the filter’s impulse response. The method is also applicable to sensor arrays for other scalar fields than pressure, such as heat, proximity, or radiation. Several methods of data extraction from the impulse response are discussed, and experimental implementation results are presented.
منابع مشابه
Distributed and Cooperative Compressive Sensing Recovery Algorithm for Wireless Sensor Networks with Bi-directional Incremental Topology
Recently, the problem of compressive sensing (CS) has attracted lots of attention in the area of signal processing. So, much of the research in this field is being carried out in this issue. One of the applications where CS could be used is wireless sensor networks (WSNs). The structure of WSNs consists of many low power wireless sensors. This requires that any improved algorithm for this appli...
متن کاملHigh-Accuracy Readout Electronics for Piezoresistive Tactile Sensors
The typical layout in a piezoresistive tactile sensor arranges individual sensors to form an array with M rows and N columns. While this layout reduces the wiring involved, it does not allow the values of the sensor resistors to be measured individually due to the appearance of crosstalk caused by the nonidealities of the array reading circuits. In this paper, two reading methods that minimize ...
متن کاملDesign and evaluation of two distributed methods for sensors placement in Wireless Sensor Networks
Adequate coverage is one of the main problems for distributed wireless sensor networks and The effectiveness of that highly depends on the sensor deployment scheme. Given a finite number of sensors, optimizing the sensor deployment will provide sufficient sensor coverage and save power of sensors for movement to target location to adequate coverage. In this paper, we apply fuzzy logic system to...
متن کاملTactile Sensor Without Wire and Sensing Element in the Tactile Region using New Rubber Material
Recently the idea of covering a robot's surface with a ‘skin’ of soft tactile sensors has attracted the attention of researchers, and some human-interactive robots covered with such sensors have actually been made (Tajima et al., 2002; Kanda et al., 2002). However, most conventional tactile sensors need a large number of sensing elements and wires because every detection point needs one sensing...
متن کاملDevelopment of soft and distributed tactile sensors and the application to a humanoid robot
This paper describes a comprehensive tactile sensor systemwhich can cover wide areas of full-body robots. Based on design criteria which are introduced from requirements, we develop two types of tactile sensor elements. One is a multi-valued touch sensor which has multi-level pressure thresholds. It is capable of coveringwide areas of robot surfaces. The other is made of soft, conductive gel, w...
متن کامل