Integrated Circuit Design in US High Energy Physics
نویسندگان
چکیده
• Small physical size: The space constraints of many detectors, most notably pixel vertex detectors, absolutely require custom microelectronics. Even when commercial electronics can be used, small ASICs can often be positioned closer to the sensor than would otherwise be possible. This reduces input capacitance and improves noise performance. In many cases the size of the cable plant is also reduced (e.g. smaller radiation length, less power dissipation on the detector, lower cooling)
منابع مشابه
Design and Development of High Gain, Low Profile and Circularly Polarized Cavity-backed Slot Antennas Using High-order Modes of Square Shaped Substrtae Integrated Waveguide Resonator
In In this paper, two low profile, single fed cavity backed slot antennas providing a circularly polarized (CP) wave are introduced. One of the antennas presents a right-handed CP (RHCP) wave, while the other one offers a left handed CP (LHCP) wave. The proposed antennas consist of a square shaped Substrtae Integrated Waveguide (SIW) cavity incorporatng two couples of radiating slots to radiate...
متن کاملEnergy Efficient Novel Design of Static Random Access Memory Memory Cell in Quantum-dot Cellular Automata Approach
This paper introduces a peculiar approach of designing Static Random Access Memory (SRAM) memory cell in Quantum-dot Cellular Automata (QCA) technique. The proposed design consists of one 3-input MG, one 5-input MG in addition to a (2×1) Multiplexer block utilizing the loop-based approach. The simulation results reveals the excellence of the proposed design. The proposed SRAM cell achieves 16% ...
متن کاملDesign Investigation of Microstrip Patch and Half-Mode Substrate Integrated Waveguide Cavity Hybrid Antenna Arrays
In this paper two linear arrays including a linear 1×4 and a planar 2×2 of microstrip patch and half-mode substrate integrated waveguide (SIW) cavity hybrid antenna are introduced and investigated. These are simply implemented using low cost single layer printed circuit board (PCB) process. The array element consists of a rectangular microstrip patch with appropriate dimensions in the vicinity ...
متن کاملDesign of power-efficient adiabatic charging circuit in 0.18μm CMOS technology
In energy supply applications for low-power sensors, there are cases where energy should be transmitted from a low-power battery to an output stage load capacitor. This paper presents an adiabatic charging circuit with a parallel switches approach that connects to a low-power battery and charges the load capacitor using a buck converter which operates in continuous conduction mode (CCM). A gate...
متن کاملNew Low Cost Printed Antenna CPW-Fed for Global Positioning System, Personal Communication System and Worldwide Interoperability for Microwave Access Band Applications (TECHNICAL NOTE)
This paper presents a new design of a CPW-Fed multi bands planar antenna. This antenna can be integrated easily with passive and active elements. The proposed antenna is suitable to operate for GPS, PCS and WiMAX bands. Its entire area is 52.3x52.6mm2 and is employed on an FR-4 epoxy substrate and fed by a 50 Ohm coplanar line. The antenna parameters have been analyzed and optimized by using AD...
متن کامل