Prognosis and evaluation of tooth damage caused by implant fixtures
نویسندگان
چکیده
Damage to adjacent teeth is one of the various complications that may occur during implant placement and is often the result of improper direction during fixture placement or excessive depth of placement. In general, if detrimental symptoms, such as reaction to percussion in damaged teeth, mobility, and pulp necrosis, are not present, osseointegration should be observed at follow-up. In three cases, the possibility of root damage due to an implant fixture placed too close to each adjacent tooth was perceived on radiographs. However, in all of these cases, there were no clinical symptoms or radiographic changes present in the tooth, and the implants did not exhibit decreased stability or peri-implantitis. Therefore, we can carefully predict that the implant fixture close to the adjacent tooth did not invade the cementum of the root, and therefore did not produce the suspected pulpal damage or periradicular symptoms. In this study, we considered both the implant status as well as the adjacent tooth.
منابع مشابه
بازسازی ناحیه قدامی فک پایین بوسیله ایمپلنت های سیستم Branemark و Bonefit بصورت متصل به یکدیگر: گزارش مورد
A 48 year old patient was candidate for anterior mandibular reconstruction by 2 fixtures of Branemark implant. Residual infection lead to removal of one of the implants from the extracted tooth socket. Afterwards, 2 fixtures of Bonefit was inserted adjacent to previously placed Branemark implants and final prosthesis were loaded in a joint cemented and screwed design.
متن کاملEvaluation of Panoramic Radiography Accuracy in Estimating the Crestal Width of Dental Implant in Different Jaw Regions
Introduction: The aim of this study was to determine the accuracy of digital panoramic radiography in estimating the crestal width of implant fixtures after surgery. Materials and Methods:We selected 241 digital panoramic images after implant insertion which had documented information of their actual size. The crestal width was measured on radiographs. We compared two measuring methods in diff...
متن کاملStress Distribution in Natural Tooth and Implant Supported Removable Partial Denture with Different Attachment Types: A Photoelastic Analysis
Background and Aim: Different attachment designs have been developed to connect implant to natural teeth in partial dentures; however, adequate studies have not been performed to determine stress distribution patterns in these designs. The present study aimed to assess stress distribution patterns in natural tooth and implant supported removable partial denture with different attachment designs...
متن کاملEvaluation of the Effect of Zirconia and Titanium Abutments on Microleakage of Implant-Abutment Interface Under Oblique Cyclic Loading In Vitro
Background and Aim: Oral bacteria can proliferate in the implant-abutment interface (IAI) and cause inflammation in the peri-implant tissues and adjacent bone. This study aimed to assess the effect of zirconia and titanium abutments on the microleakage of the IAI under oblique cyclic loading conditions. Materials and Methods: In this in-vitro study, 12 implant-abutment assemblies with zirconia...
متن کاملمقایسه نسبت های مختلف طول تاج به طول ایمپلنت (Crown: Implant) در تنش های وارد به استخوان آلوئول به روش اجزای محدود
Preservation of bone-implant interface is vital for maintaining of implant treatment. There are some cases in which crown to fixture ratio is increased due to loss of residual ridge. In this condition knowledge of stresses acting over alveolar bone is important in regard to prognosis of treatment. In this study three different crown to fixture ratios evaluated under lateral forces considering s...
متن کامل