Determination of Micromotion at the Implant Bone Interface– An In-Vitro Methodologic Study
نویسنده
چکیده
A total of 15 (n=5 per group) bone level implants (Figure 1a) with diameters of 4.7 mm at the shoulder and 3.7 mm at the apex and a length of 16 mm (SCI-BioActive; AlfaGate; KfarQara, Israel) were placed in bone surrogate materials (Figure 1b) differing in density (Solid rigid polyurethane foam, 10 pound per cubic foot (pcf), 20 pcf,
منابع مشابه
Comparative Evaluation of Microleakage at the Interface of Titanium and Zirconium Abutments Following Oblique Cyclic Loading: An in vitro Study
Abstract Background and aim: Oral microbiota could proliferate the microspace between the implant and abutment, thereby cause inflammation in the peri-implant tissues and adjacent bone. This study aimed to investigate the effect of two types of abutments (zirconia and titanium) on microleakage at implant-abutment interface area under oblique cyclic loading in vitro. Materials and methods:In thi...
متن کاملIn vitro assessments of reverse glenoid stability using displacement gages are misleading - recommendations for accurate measurements of interface micromotion.
BACKGROUND Baseplate micromotion of the reverse shoulder glenoid component can lead to implant loosening. We hypothesized that a remotely positioned displacement gage measures elastic deformation of the system rather than actual micromotion at the implant/bone interface. METHODS Reverse glenoid components were implanted into polyurethane blocks of 3 different densities. A 700 N compressive lo...
متن کاملEvaluation of the Effect of Zirconia and Titanium Abutments on Microleakage of Implant-Abutment Interface Under Oblique Cyclic Loading In Vitro
Background and Aim: Oral bacteria can proliferate in the implant-abutment interface (IAI) and cause inflammation in the peri-implant tissues and adjacent bone. This study aimed to assess the effect of zirconia and titanium abutments on the microleakage of the IAI under oblique cyclic loading conditions. Materials and Methods: In this in-vitro study, 12 implant-abutment assemblies with zirconia...
متن کاملInitial Stability of Cementless Femoral Stems: An In Vitro Technique to Measure Micromotion and Gap Around the Loaded Stem
Currently available techniques used to measure experimentally micromotion directly at the bone-implant interface rely on LVDT sensors [2]. They allow a good precision but they also include the bone deformation between the device fixation point and the measurement site. Moreover, the reported maximum number of simultaneous measurement points on bone with sensors was six [3]. Introduction Valérie...
متن کاملComparative Evaluation of Microgap at the Interface of Titanium and Zirconium Abutments Following Oblique Cyclic Loading: An in vitro Study
Abstract Background and Aim : Microgap in the implant-abutment interface is one of the main challenges in the treatment of two-piece implants. This study aimed to investigate the effect of two types of abutments (zirconia and titanium) on microgap at implant-abutment interface area under oblique cyclic loading in vitro. Methods and Materials In this in vitro study, 12 implant-abutment assemb...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2015