Porosities and Dimensions of Measures
نویسنده
چکیده
University of Geneva, Departments of Physics and Mathematics, 1211 Geneva 4, Switzerland University of Jyväskylä, Department of Mathematics, P.O. Box 35, FIN-40351 Jyväskylä, Finland [email protected], [email protected], and [email protected] Abstract. We introduce a concept of porosity for measures and study relations between dimensions and porosities for two classes of measures: measures on Rn which satisfy the doubling condition and strongly porous measures on R.
منابع مشابه
Porosities and Dimensions of Measures Satisfying the Doubling Condition
This paper explains the implications of a mathematical theory (by the same authors) of holes in fractals and their relation to dimension for measurements. The novelty of our approach is to consider the fractal measure on a set rather than just the support of that measure. This should take into account in a more precise way the distribution of data points in measured sets, such as the distributi...
متن کاملThe evaluation and assessment of deprivation level in rural areas Case: central part of Javanrood
Introduction: Poverty and deprivation are being considered as one of the master problem for the government more specifically for planners in many countries. Deprivation and combating these phenomena are in the center of regional planning. In fact regional balance attainment is being pursued as a mater regional planning target. Achieving this goal demands identification of back ward and depri...
متن کاملFree vibration behavior of bi-directional functionally graded plates with porosities using a refined first order shear deformation theory
This paper proposes the refined first order shear deformation theory to investigate the free vibration behavior of bidirectional functionally graded porous plates. This theory satisfies the transverse shear stress free conditions at the top and bottom of the plate, thus avoids the need of a shear correction factor. The rule of mixtures is employed to compute the effective material properties an...
متن کاملAn Investigation of Casting Defects Revealed in Forming Process of USD7 Steel
USD7 is one of the steel products of Isfahan Steel Company. It is cast in continuous casting moulds and rolled up to a rod of 5 mm diameter. Finally, it is wire drawn up to 3 mm and used as welding electrodes. This steel contains 0.05 to 0.09 wt. % carbon. The acceptable limit of the aluminium in this class of steel is less than 0.003 wt%. Therefore, it is categorized as rimmed steel...
متن کاملChitin Nanowhisker Aerogels
Chitin nanowhiskers are structured into mesoporous aerogels by using the same benign process used previously in our group to make cellulose nanowhisker aerogels. The nanowhiskers are sonicated in water to form a hydrogel before solvent-exchange with ethanol and drying under supercritical CO2 (scCO2 ). Aerogels are prepared with various densities and porosities, relating directly to the initial ...
متن کامل