Thermal Stability and Flammability of Styrene-Butadiene Rubber-Based (SBR) Ceramifiable Composites

نویسندگان

  • Rafał Anyszka
  • Dariusz M. Bieliński
  • Zbigniew Pędzich
  • Przemysław Rybiński
  • Mateusz Imiela
  • Mariusz Siciński
  • Magdalena Zarzecka-Napierała
  • Tomasz Gozdek
  • Paweł Rutkowski
چکیده

Ceramifiable styrene-butadiene (SBR)-based composites containing low-softening-point-temperature glassy frit promoting ceramification, precipitated silica, one of four thermally stable refractory fillers (halloysite, calcined kaolin, mica or wollastonite) and a sulfur-based curing system were prepared. Kinetics of vulcanization and basic mechanical properties were analyzed and added as Supplementary Materials. Combustibility of the composites was measured by means of cone calorimetry. Their thermal properties were analyzed by means of thermogravimetry and specific heat capacity determination. Activation energy of thermal decomposition was calculated using the Flynn-Wall-Ozawa method. Finally, compression strength of the composites after ceramification was measured and their micromorphology was studied by scanning electron microscopy. The addition of a ceramification-facilitating system resulted in the lowering of combustibility and significant improvement of the thermal stability of the composites. Moreover, the compression strength of the mineral structure formed after ceramification is considerably high. The most promising refractory fillers for SBR-based ceramifiable composites are mica and halloysite.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effect of carbon black and fly ash co-fillers content on mechanical and thermal behaviors of styrene butadiene rubber compounds

Fly ash (FA) is produced as a waste byproduct during the burning process of coal in thermal power plants whose cost is primarily associated to cleaning and transportation. It possesses mechanical properties on account of its constituents like silica and alumina. The use of FA as filler in styrene butadiene rubber (SBR) was of researchers’ interest to reinforce and/or to reduce product cost. In ...

متن کامل

High Performance Graphene Oxide Based Rubber Composites

In this paper, graphene oxide/styrene-butadiene rubber (GO/SBR) composites with complete exfoliation of GO sheets were prepared by aqueous-phase mixing of GO colloid with SBR latex and a small loading of butadiene-styrene-vinyl-pyridine rubber (VPR) latex, followed by their co-coagulation. During co-coagulation, VPR not only plays a key role in the prevention of aggregation of GO sheets but als...

متن کامل

The Rheological Behavior of Wheat Starch Particulates Filled Uncured Styrene-Butadiene Rubber

This study treats one important aspect of starch-filled rubber compounds which is their rheological behavior. Starch-based SBR1712 masterbatches resulting from various formulations were prepared using a mini two roll mill and an internal mixer (Plastograph Brabender).The content in starch was varied from 0 to 50 phr. The effect of starch content on the rheological behavior was ev...

متن کامل

Analysis of the Modifying Effect of Styrene Butadiene Rubber Latex Copolymer on Strength and Permeability Properties of Structural Light Aggregate Concrete

Polymers not only possess repairing functions concerning the concrete structures, but also due to their properties are used in making different types of polymer cements and improving the matrix structure of cement materials, enhancing the viscosity, mechanical, and stability power of concretes. Today, there is limited knowledge on the use of SBR in structural light aggregate concrete. In the pr...

متن کامل

Influence of Nanogels on Mechanical, Dynamic Mechanical, and Thermal Properties of Elastomers

Use of sulfur crosslinked nanogels to improve various properties of virgin elastomers was investigated for the first time. Natural rubber (NR) and styrene butadiene rubber (SBR) nanogels were prepared by prevulcanization of the respective rubber lattices. These nanogels were characterized by dynamic light scattering, atomic force microscopy (AFM), solvent swelling, mechanical, and dynamic mecha...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره 9  شماره 

صفحات  -

تاریخ انتشار 2016