A Case Study on Application of Fuzzy Logic in Electrical Discharge Machining (edm)
نویسندگان
چکیده
منابع مشابه
Fuzzy Modeling for Micro EDM Parameters Optimization in Drilling of Biomedical Implants Ti-6Al-4V Alloy for Higher Machining Performance
Ti6Al4V alloy is highly used in the automotive and aerospace industry due to its good machining characteristics. Micro EDM drilling is commonly used to drill micro hole on extremely hard material with very high depth to diameter ratio. In this study, the parameters of micro-electrical discharge machining (EDM) in drilling of Ti6Al4V alloy is optimized for higher machining accuracy with less hol...
متن کاملExperimental Investigation of the Pulse and Plasma Flushing Efficiency in Electrical Discharge Machining
This paper presents a study of the relationship between Electrical Discharge Machining (EDM) parameters on the EDM efficiency factors using a full factorial design, based on pulse on-time, duty cycle and tool polarity parameters in EDM machining of AISI H13 tool steel. The results show that, in positive polarity, the plasma flushing efficiency and pulse efficiency increase according to the puls...
متن کاملComparison of Fuzzy Logic and Neural Network for Modelling Surface Roughness in Edm
Surface roughness is the main indicator of technological performances of a component for electrical discharge machining (EDM). EDM process of manganese alloyed cold-work tool steel was modelled. In this paper we used the fuzzy logic (FL) and neural network (NN) to predict the effect of machining variables (discharge current and pulse duration) on the surface roughness of manganese alloyed cold-...
متن کاملOptimization of Process Parameters of Wire Electrical Discharge Machining Using Fuzzy logic Integrated with Taguchi Method
In this paper, fuzzy logic integrated with the Taguchi method is used to optimize Wire Electro Discharge Machining (WEDM) process with multiple quality characteristics. Rough machining with EDM gives poor surface finish and has micro cracks and pores. Finish machining gives better surface finish but with very poor machining speed (MRR). Spark gap width is one of the important performance measur...
متن کاملuzzy Logic Control of Microhole lectrical Discharge Machining
microhole electrical discharge machining (EDM) system with daptive fuzzy logic control and precision piezoelectric stage is eveloped in this study. A high-speed EDM monitoring system is mplemented to measure the gap voltage, current, and ignition elay time, which are used to derive three input parameters—the verage gap voltage, deviation in spark ratio, and change in the eviation in spark ratio...
متن کامل