Using an IEEE1149.1 Test Bus for Fault Diagnosis of Analog Parts of Electronic Embedded Systems
نویسندگان
چکیده
1 Gdansk University of Technology, Faculty of Electronics, Telecommunications and Informatics, Department of Metrology and Optoelectronics, ul. G. Narutowicza 11/12, 80-233 Gdansk, Poland, phone 48 58 347-14-87, fax 48 58 347-13-57, e-mail [email protected] 2 Gdansk University of Technology, Faculty of Electronics, Telecommunications and Informatics, Department of Metrology and Optoelectronics, ul. G. Narutowicza 11/12, 80-233 Gdansk, Poland, phone 48 58 347-15-37, fax 48 58 347-13-57, e-mail [email protected]
منابع مشابه
Board Level IEEE 1149 . 1 Boundary Scan Built In Self Test
IEEE1149.1 Boundary Scan has become an important test technique within complex IC's and boards in today's electronic assemblies, providing a low cost, high fault coverage test methodology for digital designs. The most common approach is for the IEEE1149.1 test to be performed in factory with test vectors being supplied by external test equipment, however new IEEE1149.1 test support devices are ...
متن کاملA Simple Fault Diagnosis Method for Analog Parts of Electronic Embedded Systems
− A new simple method of single soft fault detection and localization of analog parts in embedded electronic systems controlled by microcontrollers is presented. In the pre-testing stage of the method a fault dictionary is created based on the map of localization curves. In the measurement stage the time response to a stimulating square impulse of the analog part is applied to the input of the ...
متن کاملIEEE 1149.4 Analog and Mixed-Signal Test Bus Standard
The Analog and Mixed-Signal Boundary-Scan Standard (IEEE1149.4 hereafter referred as dot4) was developed to measure external discrete components in a mixed-signal Printed Circuit Assembly (PCA). This bus uses 4 of the same signals used today to support IEEE1149.1 compliant devices and systems. It uses two additional wires bus to perform analog monitoring and control. But testing a mixed-signal ...
متن کاملTesting of Analog Parts of Electronic Embedded Systems with Limited Access to Internal Nodes
A new class of multi-port methods based on extension of input-output two-port methods of soft fault diagnosis of passive elements in analog circuits is presented. It uses accessible internal nodes of the tested analog circuit for additional measurements of circuit time responses. Thanks to this, the fault resolution increases, that is we obtain better fault localization coverage.
متن کاملFault Diagnosis of Fully Differential Circuits in Electronic Embedded Systems
− A new Built-In-Self-Test scheme for diagnosis of analog fully differential circuits in embedded mixed-signal microsystems is presented. The measurement procedure is realized by the internal resources of the microcontroller. The real and imaginary parts of the output differential voltage are measured with common-mode excitation of the circuit under test (CUT). The diagnosis procedure is based ...
متن کامل