Simulation of Pulsed High Voltage DC Source And Blumlein Transmission Line
نویسندگان
چکیده
In the reported article, we have simulated the pulsed high voltage direct current (DC) source and Blumlein transmission line by Multisimulation13 (National Instruments, Inc). In the generation of high voltage pulses at the optimum repetition rate, we have observed and investigated the waveform behavior of voltage in the Blumlein transmission line.We present the simulation results of pulsed high voltage DC source with theoutput of 55.4 kV, operating at 131 Hz.Further, voltage waveform across the Blumlein transmission line and its various parameters such as peak to peak voltage, root mean square voltage, peak to peak current, root mean square current and rate of oscillation of Blumlein transmission line are computed. The simulation of pulsed DC source and Blumlein transmission line by Multisimulation assisted in the designing and characterization of thehands-on high voltage source and Blumlein transmission line based transversely electrical excited at atmospheric (TEA) nitrogen laser.
منابع مشابه
Design and Construction of a150kV/300A/1μs Blumlein Pulser
Blumlein pulsers are well suited devices for high voltage pulse generation in the range of nanoseconds or microseconds. They consist of pieces of transmission lines charged in parallel and discharged synchronously in series into the load by using a single switch. The main problems with this type of circuit are the presence of the shield cable impedance that contributes to the power loss of the ...
متن کاملHigh Voltage Pulse Generator by connecting Normal Coaxial Cable in series and in parallel without using Blumlein method
In order to carry out the simulation of the electrical noise, a pulse generator with fast rise time is needed. For this reason, the pulse generator using a coaxial cable is usually used. The pulse generator consists of a DC power supply, a charging resistor, a coaxial cable, a relay, and a terminator. Even the same voltage as charge voltage was outputted when the termination of the impedance wa...
متن کاملHigh Voltage Pulse Generator by connecting Normal Coaxial Cables in series and in parallel without using Blumlein method
In order to carry out the simulation of the electrical noise, a pulse generator with fast rise time is needed. For this reason, the pulse generator using a coaxial cable is usually used. The pulse generator consists of a DC power supply, a charging resistor, a coaxial cable, a relay, and a terminator. Even the same voltage as charge voltage was outputted when the termination of the impedance wa...
متن کاملModelling of n-Stage Blumlein Stacked Lines for Bipolar Pulse Generation
A Blumlein line is a particular Pulse Forming Line, PFL, configuration that allows the generation of high-voltage sub-microsecond square pulses, with the same voltage amplitude as the dc charging voltage, into a matching load. By stacking n Blumlein lines one can multiply in theory by n the input dc voltage charging amplitude. In order to understand the operating behavior of this electromagneti...
متن کاملControlling Both the DC Boost and AC Output Voltage of Z-Source Inverter Using Neural Network Controller with Minimization of Voltage Stress Across Devices
This paper presents a method to control both the dc boost and the ac output voltage of Z-source inverter using neural network controllers. The capacitor voltage of Z-source network has been controlled linearly in order to improve the transient response of the dc boost control of the Z-source inverter. The peak value of the line to line ac output voltage is used to control and keep the ac output...
متن کامل