Impact of bias current distribution on the noise figure and power saturation of a multicontact semiconductor optical amplifier.
نویسندگان
چکیده
We present an experimental investigation of a multicontact semiconductor optical amplifier. This first-generation device allows for direct control of the carrier density profile along the length of the waveguide. This is used to control the device noise figure, with a minimum value of 5 dB observed at a gain of 15 dB for an optimum carrier density profile. The opposite carrier density profile results in an increase of the power saturation by 3 dB.
منابع مشابه
Simulation and Analysis the Performance of 3970 Km DWDM Transmission Link Employing Optimized Semiconductor Optical Amplifiers
In this paper first we try to analysis the behavior ofthe SOAs in the optical networks and then have proposed anumerical simple model to simulate the behavior of thesemiconductor optical amplifiers. After that by employing thismodel as inline amplifier for a DWDM optical system, we havesimulated the transmission of 10 channels with bit rate 10 Gb/sup to distance 3970 km with RZ-DPSK modulation ...
متن کاملMethod to improve the noise figure and saturation power in multi-contact semiconductor optical amplifiers: simulation and experiment.
The consequences of tailoring the longitudinal carrier density along the active layer of a multi-contact bulk semiconductor optical amplifier (SOA) are investigated using a rate equation model. It is shown that both the noise figure and output power saturation can be optimized for a fixed total injected bias current. The simulation results are validated by comparison with experiment using a mul...
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملNoise Equivalent Power Optimization of Graphene- Superconductor Optical Sensors in the Current Bias Mode
In this paper, the noise equivalent power (NEP) of an optical sensor based ongraphene-superconductor junctions in the constant current mode of operation has beencalculated. Furthermore, the necessary investigations to optimize the device noise withrespect to various parameters such as the operating temperature, magnetic field, deviceresistance, voltage and current bias have been presented. By s...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Optics letters
دوره 36 13 شماره
صفحات -
تاریخ انتشار 2011