Selecting Controls for Water Distribution Systems
نویسنده
چکیده
One of the key requirements for reliable operation of a water supply system is a thorough analysis and proper selection of the control valves and pumps. For valves, selection criteria includes capacity, pressure loss, controllability, torque, cavitation and transients. Pump selection requires matching the pump performance to varying system demands. Examples are given for single pump operation and use of pumps in series and parallel. When future demands exceed the original design conditions, or if significant changes are required in the operation of the system, each important control device should be analyzed to see if it can operate safely at the new conditions or determine if modifications or replacement is required.
منابع مشابه
Assessment of Goodness of Fit Methods in Determining the Best Regional Probability Distribution of Rainfall Data
One of the most important problems in time series analysis of stream flow and rainfall data in an area is selecting the best probability distribution. Since the rainfall stations are associated and correlated with each other, so statistical analysis of the station data seamlessly are very important. Therefore, the first step in data analysis, is selecting the prevailing probability distribution...
متن کاملProbabilistic Contaminant Source Identification in Water Distribution Infrastructure Systems
Large water distribution systems can be highly vulnerable to penetration of contaminant factors caused by different means including deliberate contamination injections. As contaminants quickly spread into a water distribution network, rapid characterization of the pollution source has a high measure of importance for early warning assessment and disaster management. In this paper, a methodology...
متن کاملOptimal Control Pressure for Leakage Minimization in Water Distribution Systems Using Imperialist Competitive Algorithm
One of the key factors affecting leakage in water distribution systems is network pressure management by putting Pressure Reduce Valves (PRV) in the flow path and optimal regulation of these vales in water networks. This study aimed at investigating optimal pressure management problems so as to minimize leakage in water distribution networks. To do so, an approach was proposed for both optimal ...
متن کاملComparing Univariate and Multivariate Indices in Drought Monitoring
In this study, drought characteristics of Arak, Bandar Anzali, Tabriz, Tehran, Rasht, Zahedan, Shiraz and Kerman stations during the statistical period of 1956 to 2015 were studied by Reconnaissance Drought Index (RDI) and Standardized Precipitation Index. Precipitation and temperature data were needed to calculate RDI. Precipitation data was also required to estimate SPI. In this study, Drinc ...
متن کاملBIG BANG – BIG CRUNCH ALGORITHM FOR LEAST-COST DESIGN OF WATER DISTRIBUTION SYSTEMS
The Big Bang-Big Crunch (BB–BC) method is a relatively new meta-heuristic algorithm which inspired by one of the theories of the evolution of universe. In the BB–BC optimization algorithm, firstly random points are produced in the Big Bang phase then these points are shrunk to a single representative point via a center of mass or minimal cost approach in the Big Crunch phase. In this paper, the...
متن کامل