Tracking control of parallel manipulator with 3-DOF

نویسندگان

  • Gaurav Chaudhary
  • Jyoti Ohri
چکیده

A parallel three degrees of freedom (3-DOF) manipulator known as Maryland manipulator is considered in this paper. The manipulator model considered in this paper is more practical because the offset lengths are not taken zero. The trajectory tracking control of the Maryland manipulator is done using linear–quadratic regulator (LQR) based proportional–integral–derivative (PID) controller. Three sequential trajectories are used to provide complete dynamic analysis of the manipulator. The manipulator considered here is more practical because the offset lengths are not taken zero unlike previous research articles. The motivation behind using PID controller is its simplicity and effectiveness. The manipulator is a highly coupled and nonlinear system so the correct determination of control signal is very important to achieve good tracking performance. The process for selecting the PID parameters is discussed in detail and the simulations results are used to show the efficacy of the controller.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Integrator Backstepping Control of a 5 DoF Robot Manipulator with Cascaded Dynamics

In this paper, dynamic equations of motion of a 5 DoF robot manipulator including mechanical arms with revolute joints and their electrical actuators are considered. The application of integrator backstepping technique for trajectory tracking in presence of parameters of uncertainty and disturbance is studied. The advantage of this control technique is that it imposes the desired properties of ...

متن کامل

3-RPS Parallel Manipulator Dynamical Modelling and Control Based on SMC and FL Methods

In this paper, a dynamical model-based SMC (Sliding Mode Control) is proposed fortrajectory tracking of a 3-RPS (Revolute, Prismatic, Spherical) parallel manipulator. With ignoring smallinertial effects of all legs and joints compared with those of the end-effector of 3-RPS, the dynamical model ofthe manipulator is developed based on Lagrange method. By removing the unknown Lagrange multipliers...

متن کامل

ANFIS+PID Hybrid Controller Design for Controlling of a 6-DOF Robot Manipulator and its Error Convergence Analysis

In this paper, an ANFIS+PID hybrid control policy has been addressed to control a 6-degree-of freedom (6-DOF) robotic manipulator. Then its error convergence has been also evaluated. The ability to formulate and estimate the system uncertainties and disturbances along with system dynamics and rejecting the disturbances effect are some advantages of the proposed method in   comparing with the co...

متن کامل

Designing Robust Finite-Time Nonlinear Torques for a n-DOF Robot Manipulator with Uncertainties, Sector and Dead-Zone Input Nonlinearities

In this paper, a complete dynamical model is presented for an uncertain -DOF robot manipulator containing description of sector and dead-zone input nonlinearities. Next, robust finite-time tracking problem of desired trajectories is declared and formulated for the aforementioned robot manipulator. By defining innovative nonlinear sliding manifolds and developing the nonsingular terminal sliding...

متن کامل

Trajectory Tracking of a Redundant Hybrid Manipulator Using a Switching Control Method

Abstract—This paper presents the trajectory tracking control of a spatial redundant hybrid manipulator. This manipulator consists of two parallel manipulators which are a variable geometry truss (VGT) module. In fact, each VGT module with 3-degress of freedom (DOF) is a planar parallel manipulator and their operational planes of these VGT modules are arranged to be orthogonal to each other. Als...

متن کامل

Inverse dynamics and trajectory tracking control of a new six degrees of freedom spatial 3-RPRS parallel manipulator

This paper presents the complete dynamic model of a new six degrees of freedom (DOF) spatial 3-RPRS parallel manipulator. The geometry parameters of the manipulator are optimized for a given constant orientation workspace. Further, a robust task-space trajectory tracking control is also designed for the manipulator along with a nonlinear disturbance observer. To demonstrate the efficacy and sho...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2017