Finite element model updating of a truss model using incomplete modal data
نویسنده
چکیده
This paper presents an application of a two-step finite element model updating methodology to a 3D truss bridge model, with the inertial moment and elastic modulus as variables. First, the sensitivity of the change in modal parameters to variations in the physical parameters were analyzed. Based on these sensitivity analyses, the parameters that can be updated were determined. Next, the optimization of an orthogonallybased objective functional was employed in model updating using the modal data obtained from measurements on a physical structure. Sequential Quadratic Programming (SQP), a quasi-Newton approach that creates a linear search strategy applicable to non-linear minimization problems was used to acquire a precise and stable solutions. In computing the solution, the gradients of every parameter versus the objective function were determined by executing a quadratic fitting methods at each iterative step in order to improve the solution’s precision. The results of the experimental updating show that the analytical model is improved after model updating such that the natural frequencies from the finite element model better match the experimentally determined natural frequencies.
منابع مشابه
FEM Updating for Offshore Jacket Structures Using Measured Incomplete Modal Data
Marine industry requires continued development of new technologies in order to produce oil. An essential requirement in design is to be able to compare experimental data from prototype structures with predicted information from a corresponding analytical finite element model. In this study, structural model updating may be defined as the fit of an existing analytical model in the light of measu...
متن کاملDamage detection of skeletal structures using particle swarm optimizer with passive congregation (PSOPC) algorithm via incomplete modal data
This paper uses a PSOPC model based non-destructive damage identification procedure using frequency and modal data. The objective function formulation for the minimization problem is based on the frequency changes. The method is demonstrated by using a cantilever beam, four-bay plane truss and two-bay two-story plane frame with different scenarios. In this study, the modal data are provided nume...
متن کاملUpdating finite element model using frequency domain decomposition method and bees algorithm
The following study deals with the updating the finite element model of structures using the operational modal analysis. The updating process uses an evolutionary optimization algorithm, namely bees algorithm which applies instinctive behavior of honeybees for finding food sources. To determine the uncertain updated parameters such as geometry and material properties of the structure, local and...
متن کاملDAMAGE IDENTIFICATION OF TRUSSES BY FINITE ELEMENT MODEL UPDATING USING AN ENHANCED LEVENBERG-MARQUARDT ALGORITHM
This paper presents an efficient method for updating the structural finite element model. Model updating is performed through minimizing the difference of recorded acceleration of real damaged structure and hypothetical damaged structure, by updating physical parameters in each phase using iterative process of Levenberg-Marquardt algorithm. This algorithm is based on sensitivity analysis and pr...
متن کاملA Comparison Study on Various Finite Element Models of Riveted Lap Joint by the Use of Dynamic Model Updating
Till now, various models have been proposed in literature to simulate the behavior of riveted structures. In order to find the most accurate analytical method in modeling the dynamic behavior of riveted structures, a comparison study is performed on several of these models, in this research. For this purpose, experimental modal analysis tests are conducted on a riveted plate to verify the effic...
متن کامل