Design and Development of a C-band Rf Transceiver for Uavsar
نویسندگان
چکیده
An experimental Unmanned Aerial Vehicle (UAV) Synthetic Aperture Radar (SAR) Sensor has been designed and developed at Multimedia University, Malaysia. This airborne system is an inexpensive C-band, single polarisation, linear FM airborne radar sensor. The system will be used for monitoring and management of earth resources such as paddy fields, oil palm plantation and soil surface. A series of field measurements and flight test has been conducted to verify the performance of the RF transceiver. This paper highlights the design and development of the SAR RF transceiver, as well as its evaluation result.
منابع مشابه
Design of Gate-Driven Quasi Floating Bulk OTA-Based Gm–C Filter for PLL Applications
The advancement in the integrated circuit design has developed the demand for low voltage portable analog devices in the market. This demand has increased the requirement of the low-power RF transceiver. A low-power phase lock loop (PLL) is always desirable to fulfill the need for a low power RF transceiver. This paper deals with the designing of the low power transconductance- capacitance (Gm-...
متن کاملDesign and Simulation of a Clamped-Clamped Micromechanical Beam AM Frequency Mixer-Filter
In the last decade Micromechanical components for communication applications has been fabricated via IC-compatible MEMS technologies. In fact, its most important impact is not at the component level, but rather at the system level, by offering alternative transceiver architectures that reduce power consumption and enhance performance. In this paper a mixer-filter for AM frequency receiver with ...
متن کاملDesign of a Transceiver System at C-Band based on Multi- Technology
This paper presents design and simulation of a transceiver system for active phased array at C-Band using multi-technology based chips. Multi-technology feature is new emerging technique for complex RF and microwave systems designs where transceiver chips based on different fabrication technologies like MMIC, LTCC and microstrip are integrated on same RF board. Design and simulation of full tra...
متن کاملLow-Power Direct Conversion Transceiver for 915 MHz Band IEEE 802.15.4b Standard Based on 0.18 μm CMOS Technology
Trung-Kien Nguyen et al. 33 This paper presents the experimental results of a lowpower low-cost RF transceiver for the 915 MHz band IEEE 802.15.4b standard. Low power and low cost are achieved by optimizing the transceiver architecture and circuit design techniques. The proposed transceiver shares the analog baseband section for both receive and transmit modes to reduce the silicon area. The RF...
متن کاملA 2.4-GHz RF CMOS transceiver for wireless sensor applications
A radio-frequency transceiver chip was designed in a UMC RF 0.18 μm CMOS process. The target RF frequency is 2.4 GHz ISM band. The specifications are a sensibility of -60 dBm and a power transmission of 0 dBm. The power supply of the transceiver is 1.8 V. Simulations show a power consumption of 10.7 mW. Innovative topics concerning efficient power management was taken into account during the de...
متن کامل