Specific signal processing for high frequency range in Audio - Magnetotelluric
نویسنده
چکیده
The usual methodology used in magnetotelluric signal processing (MT) has been studied and applied to the case of audio-magnetotellourics (AMT). The results obtained have proved not to be good enough in order to obtain a good subsurface resistivity model. Therefore, some changes have been made to the methodology of signal processing so that it suits audio-magnetotellurics. These changes have applied to the selection of time windows and Fourier transform, to the frequency target list (its own code in Matlab), to Parzen radius and to the method of optimal transfer function estimation.
منابع مشابه
Electromagnetic receiver with capacitive electrodes and triaxial induction coil for tunnel exploration
A new type of electromagnetic (EM) receiver has been developed by integrating four capacitive electrodes and a triaxial induction coil with an advanced data logger for tunnel exploration. The new EM receiver can conduct EM observations in tunnels, which is one of the principal goals of surface-tunnel-borehole EM detection for deep ore deposit mapping. The use of capacitive electrodes enables us...
متن کاملA New High Frequency Grid Impedance Estimation Technique for the Frequency Range of 2 to150 kHz
Grid impedance estimation is used in many power system applications such as grid connected renewable energy systems and power quality analysis of smart grids. The grid impedance estimation techniques based on signal injection uses Ohm’s law for the estimation. In these methods, one or several signal(s) is (are) injected to Point of Common Coupling (PCC). Then the current through and voltage of ...
متن کاملDesign and Implementation of Digital Demodulator for Frequency Modulated CW Radar (RESEARCH NOTE)
Radar Signal Processing has been an interesting area of research for realization of programmable digital signal processor using VLSI design techniques. Digital Signal Processing (DSP) algorithms have been an integral design methodology for implementation of high speed application specific real-time systems especially for high resolution radar. CORDIC algorithm, in recent times, is turned out to...
متن کاملGrid Impedance Estimation Using Several Short-Term Low Power Signal Injections
In this paper, a signal processing method is proposed to estimate the low and high-frequency impedances of power systems using several short-term low power signal injections for a frequency range of 0-150 kHz. This frequency range is very important, and thusso it is considered in the analysis of power quality issues of smart grids. The impedance estimation is used in many power system applicati...
متن کاملDesign of a High Range, High Efficiency Spread Spectrum Transmitter for Audio Communication Applications
This work proposes a direct sequence spread spectrum transmitter with high transmission range and efficiency for audio signals. It is shown that by choosing high process gain for spread spectrum signal the data could reach a range of 55km in the 2.4GHz ISM band. By employing a light modulation scheme, we have a relaxed SNR requirement for having a low bit error rate (BER) which translates to re...
متن کامل