Flow and Mixing Performance in Helical Ribbon Mixers

This paper explores the effect of impeller design on the chaotic mixing in a helical ribbon mixer. Numerical simulations using the Smoothed Particle Hydrodynamics (SPH) method are used to solve for the fluid flow around the moving impellor. The mixing flow is visualised by extracting the hyperbolic Lagrangian Coherent Structures (LCS) of the flow from the Finite-Time Lyapunov Exponent (FTLE) field, which provides qualitative information about the topology of the mixing structures and highlights the major barriers to transport. This is combined with a mixing measure that calculates the degree of mixing between different regions. A single helical ribbon mixer (SHR) was found to create an axially symmetric circulation cell that moves fluid down the outside of the tank and upward near the centre. Smaller circulation cells near the inside edge of the ribbon superimpose a chaotic mixing flow over this primary flow, which stretches and folds fluid volumes around the ribbon according to the shape of the LCSs. The horizontal struts supporting the ribbon generate strong circumferential mixing, but this is only within a narrow horizontal plane with thickness comparable with the strut diameter. The addition of an extra ribbon, 180 degrees out of phase (DHR) doubles the number of smaller circulation cells while decreasing their efficiency in mixing the fluid between the inner and outer regions of the tank. Overall the mixing rate is improved over the other ribbon geometries. The 1 Corresponding author Current Address: Multiscale Mechanics group, Faculty of Engineering Technology University of Twente, P.O. Box 217, 7500 AE Enschede, Netherlands E-mail: [email protected] phone: +31 53 4893061 Prepared for Chemical Engineering Science addition of a central screw (CSR) creates a zone of low mixing immediately surrounding the screw. The mixing processes surrounding the helical ribbon are qualitatively identical to the SHR, but the overall mixing rate is slightly increased.