Electrical characterization of micro-organisms using microfabricated devices
نویسندگان
چکیده
This article describes the electrical characterization of live and heat-inactivated micro-organisms within microstructures. Electrophoretic movement of live and heat-inactivated Listeria innocua on interdigitated fingered electrodes confirmed the presence of negative charges on the live micro-organisms and demonstrated positive or neutral charges on the heat-inactivated micro-organisms. A micropore was fabricated in an oxide coated silicon diaphragm, which was placed between two chambers containing ionic buffer solutions. When the micro-organism electrophoretically traversed the pore, the background ionic current was blocked and a decrease in the current was observed. As an initial test case, negatively charged polystyrene beads, which were 2.38 mm in diameter, were electrophoretically driven across the pore. Then, Listeria innocua, suspended in tris-glycine buffer, were also moved through the pore and their electrophoretic mobility was determined. In addition, the values of mobility of the micro-organisms through the micropore were found to be about 3 orders of magnitude smaller than their mobility without the pore, which can be explained by the higher hydrostatic pressures experienced by the micro-organisms when traversing through the pore. © 2002 American Vacuum Society. @DOI: 10.1116/1.1508805#
منابع مشابه
Optimal Design and Operation of Fuel Cell Systems for Micro Power Generation
Currently, the predominant technologies for autonomous portable electrical power supply are batteries. A promising potential alternative is devices that generate electrical power through electrochemical conversion of easily stored fuels in microfabricated fuel cells. These devices are consumer products that are entire micro-scale chemical processes, and it is necessary to explore their optimal ...
متن کاملProgress toward a Microfabricated Gas Turbine Generator for Soldier Portable Power Applications
MEMS turbocharger and electric generator devices have been fabricated and tested as part of a program at MIT to develop a microfabricated gas turbine generator for portable power applications. The overall efficiency of this device, relative to its conventional-scale brethren, is limited by small-scale physics and microfabrication constraints. However, even at modest efficiency levels, the perfo...
متن کاملOptical pumping in a microfabricated Rb vapor cell using a microfabricated Rb discharge light source
Miniature (<few cm) vapor-cell based devices using optical pumping of alkali atoms, such as atomic clocks and magnetometers, today mostly employ vertical-cavity surface-emitting lasers as pump light sources. Here, we report on the demonstration of optical pumping in a microfabricated alkali vapor resonance cell using (1) a microfabricated Rb discharge lamp light source, as well as (2) a convent...
متن کاملBiomedical Applications of Mems
Micromachining and MEMS technologies can be used to produce complex electrical, mechanical, fluidic, thermal, optical, and magnetic structures, devices, and systems on a scale ranging from organs to subcellular organelles. This miniaturization ability has enabled MEMS to be applied in many areas of biology, medicine, and biomedical engineering – a field generally referred to as BioMEMS. The fut...
متن کاملFabrication of Copper and Iron Nano/Micro Structures on Semiconducting Substrate and Their Electrical Characterization
In this paper, we have studied the electrical properties of the randomly distributed metallic (Co and Fe) nano/ micro wires on Silicon substrate. Deposition was carried out potentiostatically into the pores of the track-etch polycarbonate membrane spin coated onto the Si substrate. Spin coated films were irradiated with 150MeV Ni (+11) ions at a fluence of 8E7 ions/cm2, followed by UV irradiati...
متن کامل