Research on Operating Condition Effect on the Shock Pulse Method
نویسندگان
چکیده
Rolling bearings are one of the most widely used elements in industrial applications. Shock pulse method (SPM) has proven successfully as a diagnostic tool in determining bearing health. On the basis of illustrating the principle of SPM, this paper mainly concentrates on investigating the effect of different operating conditions on SPM. The shock pulse signals are derived from the wind turbine gearbox test rig by SPM instrument. Through comparing the slope of dB values when the rotating speed or load changes, effect of operating conditions on SPM is analyzed. The analysis results show that SPM is more sensitive to the rotating speed in contrast with the load.
منابع مشابه
Effects of Far- and Near-Field Multiple Earthquakes on the RC SDOF Fragility Curves Using Different First Shock Scaling Methods
Typically, to study the effects of consecutive earthquakes, it is necessary to consider definite intensity levels of the first shock. Methods commonly used to define intensity involve scaling the first shock to a specified maximum interstorey drift. In this study the structure’s predefined elastic spectral acceleration caused by the first shock is also considered for scaling. This study aims to...
متن کاملThe Effect of Budget Deficit Shock on Government Spending: An Empirical Case in Indonesia
This paper aims to investigate the effect of budget deficit shock on government spending in Indonesia. For this propose, this reasearch uses an alternative error correction model based on loss function of government spending. The model assumes the short run disequilibrium, in which shock variables may play an important role. A spesific loss function model is applied to develop the long run gove...
متن کاملAn Optimization on the DIN1.2080 Alloy in the Electrical Discharge Machining Process Using ANN and GA
Electrical Discharge Machining (EDM) process is one of the most widely used methods for machining. This method is used to form parts that conduct electricity. This method of machining has used for hard materials and therefore selects the correct values of parameters which are so effective on the quality machining of parts. Reaching to optimum condition of the DIN1.2080 alloy (D3) machining is v...
متن کاملAn Optimization on the DIN1.2080 Alloy in the Electrical Discharge Machining Process Using ANN and GA
Electrical Discharge Machining (EDM) process is one of the most widely used methods for machining. This method is used to form parts that conduct electricity. This method of machining has used for hard materials and therefore selects the correct values of parameters which are so effective on the quality machining of parts. Reaching to optimum condition of the DIN1.2080 alloy (D3) machining is v...
متن کاملThe Effect of Heat Shock on Production of Recombinant Human Interferon Alpha 2a (rhIFN α -2a) by Escherichia coli
Recombinant human interferon alpha 2a (rhIFN α -2a) production and cell growth were monitored in a set of genetically modified E. coli strains (MSD1519, MSD1520, MSD 1521, MSD 1522, MSD 1523) producing rhIFN α -2a. The growth was followed at OD 600 nm, changes in cell physiology were detected by pyrolysis mass spectrometry (PyMS) of cell biomass and recombinant protein production was determined...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2014