23. Frontal Thrust, Oregon Accretionary Prism: Geometry, Physical Properties, and Fluid Pressure

نویسندگان

  • J. Casey Moore
  • Kate Moran
  • Mary E. MacKay
  • Harold Tobin
چکیده

The frontal thrust of the Oregon accretionary prism scrapes off about 2 km of incoming sedimentary section and underlies a fault-bend fold of the first ridge landward of the abyssal plain. Scarps with associated chemosynthetic biological communities at the surface and pore-water anomalies at depth indicate that the frontal thrust is tectonically and hydrologically active. At Site 891, near seismic line OR-5, the thrust splits into at least three splays from 375 to 500 mbsf. The upper splay is defined in the cores by strongly developed scaly fabric and is mostly positive polarity on seismic reflection lines. The middle splay shows low to moderate deformation in the cores. Drilling did not penetrate the lower splay. The middle and lower splays are mostly negative polarity on the seismic reflection data. At Ocean Drilling Program (ODP) Site 891 the upper splay is marked by increased velocity and density on borehole logs, which explains its positive polarity reflection. In core samples the middle splay is associated with a velocity and density decrease about 10 m thick that explains its negative polarity reflection. Four techniques were used to estimate fluid pressure from the anomalously porous interval associated with the middle splay of the frontal thrust: (1) comparison of porosity and effective overburden to an undeformed reference section in Cascadia Basin; (2) comparison of the porosity-depth profile over this interval with the normally consolidated porosity-depth function determined from one-dimensional consolidation tests on recovered samples; (3) comparison of the undrained shear strength/ overburden pressure ratio (Su/P0') with the same ratio for normally consolidated clays; and (4) direct measurement of sediment stress history from consolidation tests. These four methods result in a range of fluid pressure ratios (λ) from 0.88 to 0.99 that indicates nearly lithostatic fluid pressures associated with the middle splay of the frontal thrust. Overall the frontal thrust at Site 891 evolves from a fluid-rich, high-fluid-pressure state, as exemplified by the middle and lower splays, to the dense, collapsed mature state of the upper splay. The frontal thrust is thus undergoing "in sequence" or seaward migration into the footwall, associated with dewatering and densification. Rapid burial of the highly porous sediment associated with the middle splay preserved near-surface effective stresses by high fluid pressures, which were perhaps temporarily sealed by the low transverse permeability of the enveloping fault strands.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Three-dimensional splay fault geometry and implications for tsunami generation.

Megasplay faults, very long thrust faults that rise from the subduction plate boundary megathrust and intersect the sea floor at the landward edge of the accretionary prism, are thought to play a role in tsunami genesis. We imaged a megasplay thrust system along the Nankai Trough in three dimensions, which allowed us to map the splay fault geometry and its lateral continuity. The megasplay is c...

متن کامل

Heat flow and fluid flow regime in the western Nankai accretionary prism

The thermal structure of the western Nankai subduction zone has been studied through surface heat flow measurements with conventional geothermal probes and estimation of heat flow from depths of gas hydrate bottom simulating reflectors. Temperature and thermal conductivity measurements at ODP Site 808, located at the toe of the Nankai accretionary prism, added important information on any varia...

متن کامل

Ocean Drilling Program Leg 170 Scientific Prospectus Costa Rica Accretionary Wedge

To gain a better understanding of the mechanical and chemical behavior of accretion and underplating and tectonic erosion and to determine how deformation and dewatering are distributed throughout an accretionary prism, it is essential to establish the flow pattern of materials through subduction systems. Leg 170 consists of a program of drilling at four primary sites (proposed Sites CR-1 throu...

متن کامل

Tectonic wedging along the rear of the offshore Taiwan accretionary prism

The structural geometry, kinematics and density structure along the rear of the offshore Taiwan accretionary prism were studied using seismic reflection profiling and gravity modeling. Deformation between the offshore prism and forearc basin at the point of incipient collision, and southward into the region of subduction, has been interpreted as a tectonic wedge, similar to those observed along...

متن کامل

Accretionary prisms in subduction earthquake cycles: The theory of dynamic Coulomb wedge

[1] We expand the theory of critically tapered Coulomb wedge for accretionary prisms by considering stress changes in subduction earthquake cycles. Building on the Coulomb plasticity of the classical theory, we assume an elastic–perfectly Coulomb plastic rheology and derive exact stress solutions for stable and critical wedges. The new theory postulates that the actively deforming, most seaward...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2006