Optimization of Enhanced Surfaces for High Flux Chip Cooling by Pool
نویسندگان
چکیده
A high flux electronic chip was numerically and experimentally simulated to investigate pool boiling capabilities of enhanced metallic surface attachments built upon a 12.7 x 12.7 mm base area. It is shown how experimental nucleate boiling data for aflat chip and for chips with low-profile microstructures can be used as input boundary conditions in the numerical prediction of boiling performances of high flux, smooth and microstructured extended cylindrical surfaces. A technique for extending the applicability of the numerical results to cylindrical fin arrays is demonstrated with the aid of experimental data obtained for these surfaces. Surface enhancement resulted in chip planform heat fluxes of 105.4 and 159.3 fV/cm, for saturated and 35°C subcooled FC-72, respectively.
منابع مشابه
Pool Boiling Heat Transfer and Bubble Dynamics Over Plain and Enhanced Microchannels
Pool boiling is of interest in high heat flux applications because of its potential for removing large amount of heat resulting from the latent heat of evaporation and little pressure drop penalty for circulating coolant through the system. However, the heat transfer performance of pool boiling systems is not adequate to match the cooling ability provided by enhanced microchannels operating und...
متن کاملParametric Inwestigation Into the Effects of Pressure, SubcooIing3 Surface Augmentation and Choice of Coolant on Pool Boiling in the Design of Cooling Systems for High-Power-Density Electronic Chips
A high power electronic chip was simulated experimentally to investigate upper cooling capabilities using a variety of pool boiling enhancement techniques. Parametric effects of system pressure, subcooling, surface augmentation, and choice of coolant on boiling heat transfer from a vertical 12.7'x 12.7 mm flat surface were examined. The two fluorocarbon coolants tested, FC-72 and FC-87, resulte...
متن کاملTitle of Document : FORCE FED MICROCHANNEL HIGH HEAT FLUX COOLING UTILIZING MICROGROOVED SURFACES
Title of Document: FORCE FED MICROCHANNEL HIGH HEAT FLUX COOLING UTILIZING MICROGROOVED SURFACES Edvin Cetegen, Doctor of Philosophy, 2010 Directed By: Michael Ohadi, Professor Department of Mechanical Engineering Among other applications, the increase in power density of advanced electronic components has created a need for high heat flux cooling. Future processors have been anticipated to exc...
متن کاملExperimental Study for Investigating the Mechanism of Heat Transfer near the Critical Heat Flux in Nucleate Pool Boiling
Heat transfer coefficient in nucleate pool boiling near critical heat flux at least one orderhigher than the convectional heat transfer modes. In this paper, an experimental setup isdesigned and fabricated to investigate the mechanism of heat transfer from boiling surface tobulk liquid near critical heat flux. The images of pool boiling near the high heat flux regionreveals that the individual ...
متن کاملOn - Chip Thermoelectric Cooling of Semiconductor Hot Spot
Title of Dissertation: On-Chip Thermoelectric Cooling of Semiconductor Hot Spot Peng Wang, Doctor of Philosophy, 2007 Directed By: Professor Avram Bar-Cohen Assistant Professor Bao Yang Department of Mechanical Engineering The Moore’s Law progression in semiconductor technology, including shrinking feature size, increasing transistor density, and faster circuit speeds, is leading to increasing ...
متن کامل