Particle size, volume fraction and matrix strength effects on fatigue behavior and particle fracture in 2124 aluminum-SiCp composites
نویسندگان
چکیده
The effects of particle size, volume fraction and matrix strength on the stress-controlled axial fatigue behavior and the probability of particle fracture were evaluated for 2124 aluminum alloy reinforced with SiC particles. Average particle sizes of 2, 5, 9 and 20/~m and volume fractions of 0.10, 0.20 and 0.35 were examined for four different microstructural conditions. Tensile and yield strengths and fatigue life were substantially higher in the reinforced alloys. Strength and fatigue life increased as reinforcement particle size decreased and volume fraction loading increased. The frequency of particle fracture during crack propagation was found to be dependent on matrix strength, particle size and volume fraction and on maximum crack tip stress intensity. Particle fracture can be rationalized, phenomenologically, by the application of modified process zone models, originally derived for static fracture processes, and weakest link statistics which account for the dependence of matrix yield strength and flow behavior and particle strength on the probability of particle fracture during monotonic fracture and fatigue crack propagation.
منابع مشابه
Effect of the Particle Size on the Deformation and Fracture Behavior of Al/4vol.%Al2O3 Composite Produced by Accumulative Roll Bonding (ARB)
In this study, Al/Al2O3 composites with two different particle sizes of 1 µm and 0.3 µm were produced via accumulative roll bonding (ARB). The microstructure evolution, mechanical properties and fracture behavior of the composites were investigated. Results show that higher ARB cycles are required to achieve a uniform distribution of particles in the composite with 0.3 µm particle size. During ...
متن کاملFatigue crack growth resistance in SiC particulate and whisker reinforced P/M 2124 aluminum matrix composites
Fatigue crack growth is examined in P/M 2124 aluminum alloys reinforced with SiC particles (SiCp) and whiskers (SiCw) over a wide spectrum of growth rates from 10 to 10 m per cycle. Effects of aging treatment, orientation of crack growth direction with respect to the rolling direction, mean stress (or stress ratio), and reinforcement volume percent on the fatigue crack growth threshold are inve...
متن کاملEffect of particle size and volume fraction on tensile properties of fly ash/polyurea composites
Fly ash, which consists of hollow particles with porous shells, was introduced into polyurea elastomer. A one-step method was chosen to fabricate pure polyurea and the polyurea matrix for the composites based on Isonate® 2143L (diisocyanate) and Versalink® P-1000 (diamine). Scanning electron microscopy was used to observe the fracture surfaces of the composites. Particle size and volume fractio...
متن کاملبررسی تأثیر فرآیند اکستروژن بر ریزساختار و استحکام کامپوزیت Al6061-SiC
Al-SiC composites are among the most demanding metal matrix composites due to their excellent strength, good ductility, good corrosion resistance, low coefficient of thermal expansion and reasonable price. Manufacturing of cast metal matrix composites usually involves some problems such as inhomogeneous distribution of the particles due to poor wetability of ceramics to molten alloys, porosity ...
متن کاملSoldering of Aluminum Matrix Composites Sicp/a356 and Kovar Alloy
Article history: Received 28.3.2013 Received in revised form 26.4.2013 Accepted 29.4.2013 Aluminum matrix composites containing 55% SiC particle reinforcing phase/SiC reinforcement phase particle and Kovar alloy 4J29 were chosen as the base metals. After nickel plating on the surface of SiCp/Al, two kinds of materials were soldered together by using Zn-Cd-Ag-Cu as the filler metal and ZnCl2 as ...
متن کامل