Ohmic contacts to N-face p-GaN using Ni/Au for the fabrication of polarization inverted light-emitting diodes.

نویسندگان

  • Seung Cheol Han
  • Jae-Kwan Kim
  • Jun Young Kim
  • Dong Min Lee
  • Jae-Sik Yoon
  • Jong-Kyu Kim
  • E F Schubert
  • Ji-Myon Lee
چکیده

The electrical properties of Ni-based ohmic contacts to N-face p-type GaN were investigated. The specific contact resistance of N-face p-GaN exhibits a linear decrease from 1.01 omega cm2 to 9.05 x 10(-3) omega cm2 for the as-deposited and the annealed Ni/Au contacts, respectively, with increasing annealing temperature. However, the specific contact resistance could be decreased down to 1.03 x 10(-4) omega cm2 by means of surface treatment using an alcohol-based (NH4)2S solution. The depth profile data measured from the intensity of O1s peak in the X-ray photoemission spectra showed that the alcohol-based (NH4)2S treatment was effective in removing the surface oxide layer of GaN.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

InGaN/GaN light emitting diodes with Ni/Au, Ni/ITO and ITO p-type contacts

The optical and electrical properties of indium tin oxide (ITO)(60 nm), Ni(3.5 nm)/ITO(60 nm) and Ni(5 nm)/Au(5 nm) films were studied. It was found that the normalized transmittance of ITO and Ni/ITO films could reach 98.2% and 86.6% at 470 nm, which was much larger than that of the Ni/Au film. It was also found that both Ni/ITO and Ni/Au could form good ohmic contact on top of p-GaN. In contr...

متن کامل

INTEGRATION OF N- AND P-CONTACTS TO GaN-BASED LIGHT EMITTING DIODES

Low-resistance Ohmic contacts are essential for the fabrication of electrical devices. While low contact resistance has been achieved to p-type layers or n-type layers separately, contacts are likely to degrade when both types need to be integrated into a single fabrication process, in particular when prior mesa etching is required. We present a solution to the problem, resulting in low-resista...

متن کامل

High-transparency Ni/Au ohmic contact to p-type GaN

In this study, a very thin Ni/Au bilayer metal film was prepared by electron beam evaporation and thermal alloying to form ohmic contact on p-type GaN film. After thermal alloying, the current– voltage (I – V) characteristic of Ni/Au contact on p-type GaN film exhibited ohmic behavior. The Ni/Au contacts showed a specific contact resistance of 1.7310 V cm at an alloying temperature of 450 °C. I...

متن کامل

Novel Type of Ohmic Contacts to P-Doped GaN Using Polarization Fields in Thin InxGa-xN Capping Layers

The performance of devices fabricated from GaN and related compounds is strongly affected by the resistances caused by electrical contacts. To avoid excessive heating resulting in a failure of the device, speciŽc contact resistances less than ,10 Wcm for light-emitting diodes (LEDs) and less than ,10 Wcm for laser diodes are required. This applies in particular to ohmic contacts on p-doped GaN ...

متن کامل

Low resistivity Hf/Al/Ni/Au Ohmic Contact Scheme to n-Type GaN

The electrical and structural properties of Hf/Al/Ni/Au (20/100/25/50 nm) ohmic contact to n-GaN are reported in this study. Specific contact resistivities of Hf/Al/Ni/Au based contacts have been investigated as a function of annealing temperature and achieve the lowest value of 1.09×10 Ω·cm after annealing at 650 C in vacuum. A detailed mechanism of ohmic contact formation is discussed. By usi...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Journal of nanoscience and nanotechnology

دوره 13 8  شماره 

صفحات  -

تاریخ انتشار 2013