Measurement and Analysis of High Temperature Using Distributed Fiber Optic Sensor
نویسندگان
چکیده
In this paper the working principle and application status of distributed optical fiber temperature sensor, amplified spontaneous Raman scattering phenomenon and its time-domain characteristics are analyzed. A new measuring principle based on amplified spontaneous Raman scattering light pulse signal temperature effect is presented, and is applied to distributed optical fiber sensor systems. Noise inevitably exists in data collected by distributed optical fiber temperature sensing systems. According to the needs of high-temperature oil well testing, distributed high temperature single-mode fiber sensors and detection equipment are designed, and gives two-dimensional data of oil well temperature testing. Because of the weak Raman backwards scattered signal and serious noise disturbance, multi-resolution wavelet analysis and reconstruction method are adopted for the denoising of testing signal.
منابع مشابه
Fiber - Optic Sensing of Linear Thermal Expansion (RESEARCH NOTES)
The use of a LED fiber-optic sensor to measure displacement and linear thermal expansion is described. It has a sensitivity of about 0.6 mV/mm, a resolution of 1.25 mm, and a dynamic rang of 400 mm for displacement measurements. For thermal expansion, it shows a sensitivity of about 3.5 mV/C, and the experimental linear expansion values are in agreement with those calculated. The reported senso...
متن کاملA fiber optic sensor for measuring glucose in aqueous solutions
In this paper, the set-up of a multi-mode fiber optic sensor for measuring glucose in aqueous solutions is investigated and evaluated. The basis of this sensor is based on the Fresnel Reflection. In this setup, a helium-neon laser is used as a light source, a fiber optic probe, photocell as detector and a digital multimeter. The statistical analysis of the recorded data shows a highly linear be...
متن کاملHigh Precision Temperature Insensitive Strain Sensor Based on Fiber-Optic Delay
A fiber-optic delay based strain sensor with high precision and temperature insensitivity was reported, which works on detecting the delay induced by strain instead of spectrum. In order to analyze the working principle of this sensor, the elastic property of fiber-optic delay was theoretically researched and the elastic coefficient was measured as 3.78 ps/km·με. In this sensor, an extra refere...
متن کاملIntrinsic Fabry-Perot Interferometric Fiber Sensor Based on Ultra-Short Bragg Gratings for Quasi-Distributed Strain and Temperature Measurements
(Abstract) The health monitoring of smart structures in civil engineering is becoming more and more important as in-situ structural monitoring would greatly reduce structure life-cycle costs and improve reliability. The distributed strain and temperature sensing is highly desired in large structures where strain and temperature at over thousand points need to be measured simultaneously. It is d...
متن کاملAnalysis of a distributed fiber-optic temperature sensor using single-photon detectors.
We demonstrate a high-accuracy distributed fiber-optic temperature sensor using superconducting nanowire single-photon detectors and single-photon counting techniques. Our demonstration uses inexpensive single-mode fiber at standard telecommunications wavelengths as the sensing fiber, which enables extremely low-loss experiments and compatibility with existing fiber networks. We show that the u...
متن کامل