of Silesian University of Technology . Series Transport
نویسندگان
چکیده
This article deals with the design of helicopter UAV airframe components. There is a description of UAV airframe design modelling involving already existing components in three-dimensional (3D) form. The modelling methodology focuses in detail on proposed bulkheads by using “top-downbottom-up” methodology. In conclusion, there is a brief description of all proposed bulkheads and an outline of possible solutions for how to design airframe stringers.
منابع مشابه
of Silesian University of Technology . Series Transport
This article defines the typical damage to components of turbine engines, highlighting the differences between them and indicating possible causes. The distinction between various types of defects helps to explain the occurrence and supports personnel in defining the most suitable maintenance action to be performed. The defects described below are common in high-airflow turbine aviation engines...
متن کاملTHE EFFECTS OF MASS TRANSFER IN THE LIQUID PHASE ON THE RATE OF ALUMINIUM EVAPORATION FROM THE Ti-6Al-7Nb ALLOY
L. Blacha, Silesian University of Technology, Faculty of Materials Engineering and Metallurgy, Katowice J. Mizera, Warsaw University of Technology, Faculty of Materials Engineering, Warszawa P. Folęga, Silesian University of Technology, Faculty of Transport, Katowice, Poland In the present paper, the rate of aluminium evaporation from the Ti-6Al-7Nb alloy during smelting with the use of VIM met...
متن کاملAn Analog and Digital Communications Laboratory with Matlab
1 Jan Chojcan, Silesian University of Technology, Gliwice POLAND, passed away on June 8 2 Jacek Izydorczyk, Silesian University of Technology, Gliwice POLAND, [email protected] 3 Grzegorz Dziwoki, Silesian University of Technology, Gliwice POLAND, [email protected] Abstract Faculty of Automatic Control, Electronics and Computer Science of the Silesian University o...
متن کاملAlSi17Cu5Mg ALLOY AS FUTURE MATERIAL FOR CASTINGS OF PISTONS FOR INTERNAL COMBUSTION ENGINES
J. Piątkowski, The Silesian University of Technology, Faculty of Materials Science and Metallurgy, Katowice, Poland The paper presents chosen properties and microstructure of AlSi17Cu5Mg alloy as future material for casting pistons in automotive industry. Tests were conducted to elaborate technology of preparation, assessment of crystallisation parameters and shaping the primary structure of th...
متن کاملMICROSTRUCTURE OF AlSi17Cu5 ALLOY AFTER OVERHEATING OVER LIQUIDUS TEMPERATURE
J. Piątkowski The Silesian University of Technology, Faculty of Materials Science and Metallurgy, Katowice, Poland R. Wieszała, The Silesian University of Technology, Faculty of Transport, Katowice, Poland The paper presents microstructure tests of alloy AlSi17Cu5. In order to disintegrate the primary grain of silicon the so-called time-temperature transformation TTT was applied which was based...
متن کامل