Direct Laser Deposition of a Single-Crystal Ni3Al-Based IC221W Alloy
نویسنده
چکیده
Single-crystal (SX) nickel aluminide alloys have potential for structural applications where hightemperature strength and oxidation resistance are required. In this work, SX deposits of the Ni3Albased IC221W alloy were produced on a SX Ni-base superalloy substrate by means of the laser-engineered net shaping (LENS) process. The microstructure of the deposits was characterized. The effects of processing parameters on the SX solidification in the melt pool and on the fabricability by LENS were investigated. A simple relationship between the ratio of the temperature gradient to the growth velocity and the processing parameters was derived, which can be used qualitatively to guide the proper selection of processing conditions to maintain the columnar dendritic growth during the laser deposition. On the basis of analyses and experiments, the effects of processing parameters on the susceptibility to stray grain formation and solidification cracking are discussed.
منابع مشابه
Laser Direct Metal Deposition of 2024 Al Alloy: Trace Geometry Prediction via Machine Learning
Laser direct metal deposition is an advanced additive manufacturing technology suitably applicable in maintenance, repair, and overhaul of high-cost products, allowing for minimal distortion of the workpiece, reduced heat affected zones, and superior surface quality. Special interest is growing for the repair and coating of 2024 aluminum alloy parts, extensively utilized for a wide range of app...
متن کاملParametric Investigation of Diode and CO2 Laser in Direct Metal Deposition of H13 Tool Steel on Copper Substrate
In the present investigation, H13 tool steel has been deposited on copper alloy substrate using both CO2 and diode laser. A detailed parametric analysis has been carried out in order to find out optimum processing zone for coating defect free H13 tool steel on copper alloy substrate. Followed by parametric optimization, the microstructure and microhardness of the deposited clads have been evalu...
متن کاملEFFECT OF CARBON ADDITION ON FUNCTIONAL AND MECHNICAL PROPERTIES OF THE Ni3Al PHASE
E. Olejnik, A. Janas, B. Grabowska, M. Kawalec, AGH University of Science and Technology, Faculty of Foundry Engineering, Krakow, Poland Casting technology was applied and research was carried out on two alloys based on the Ni3Al phase with variable carbon content of 0,2 and 1,25 wt. % C, respectively. Resistance to abrasive wear, friction coeffi cient and Vickers microhardness were determined....
متن کاملINVESTIGATION ON GROWTH AND CHARACTERIZATION OF NONLINEAR OPTICAL DICHLORO-DIGLYCINE ZINC II SINGLE CRYSTAL
The study of amino acid based nonlinear optical (NLO) materials with optimum physical properties is an important area due to their practical applications such as optical communication, optical computing, optical information processing, optical disk data storage, laser fusion reactions, laser remote sensing, colour display, medical diagnostics, etc. Also, microelectronic industries require cryst...
متن کاملBottom-up approach for the low-cost synthesis of graphene-alumina nanosheet interfaces using bimetallic alloys.
The production of high-quality graphene-oxide interfaces is normally achieved by graphene growth via chemical vapour deposition on a metallic surface, followed by transfer of the C layer onto the oxide, by atomic layer and physical vapour deposition of the oxide on graphene or by carbon deposition on top of oxide surfaces. These methods, however, come with a series of issues: they are complex, ...
متن کامل