Selected Technological Factors Influencing the Modulus of Elasticity of Concrete
ثبت نشده
چکیده
The topic of the article focuses on the evaluation of selected technological factors and their influence on resulting elasticity modulus of concrete. A series of various factors enter into the manufacturing process which, more or less, influences the elasticity modulus. This paper presents the results of concrete in which the influence of water coefficient and the size of maximum fraction of the aggregate on the static elasticity modulus were monitored. Part of selected results of the long-term programme was discussed in which a wide scope of various variants of proposals for the composition of concretes was evaluated. Keywords—Mix design, water-cement ratio, aggregate, modulus of elasticity.
منابع مشابه
Experimental study of impact strength and modulus of elasticity of reinforced concrete under ambient temperature, used in concrete dams
The choice of concrete consumption and high strength in the structure of concrete dams is of particular importance. In this laboratory research, slag alkaline concrete containing 0, 4 and 8% nanosilica and 1 and 2% polyolefin fibers has been produced in 5 mixing designs. A design of control concrete containing Portland cement was prepared to compare with the test results of reinforced concre...
متن کاملControl of Engineering Properties of Asphalt Concrete Based on Permanent Deformation Constraint of Subgrade at Tropical Zones in Iran (TECHNICAL NOTE)
The permanent deformation pavement of roads and streets at tropical zones Abstract (if layers are sufficiently compacted) is due to increase of asphalt layers temperature and consequential decrease of modulus of elasticity. Therefore, the asphalt mixture moves aside of the wheels of heavy vehicles and cause permanent deformations without volume variation. On the other hand, if the asphalt layer...
متن کاملApproach to Design of Composition of Current Concrete with Respect to Strength and Static Elasticity Modulus
The paper reflects current state of popularization of static elasticity modulus of concrete. This parameter is undoubtedly very important for designing of concrete structures, and very often neglected and rarely determined before designing concrete technology itself. The paper describes assessment and comparison of four mix designs with almost constant dosage of individual components. The only ...
متن کاملLaboratory study of mechanical properties of ordinary concrete under high heat consumption in hydraulic structures, along with validation by SEM and XRD tests
In this laboratory research, a mixing plan was made of ordinary concrete containing Portland cement type 2 with a grade of 500 kg / m3. Compressive strength, tensile strength and modulus of elasticity tests of concrete were performed on concrete samples at 90 days of processing age at 21 °C and 600 ° C. In order to further evaluate and validate the results, SEM and XRD tests were performed on c...
متن کاملEstimating an appropriate plastic concrete mixing design for cutoff walls to control leakage under the earth dam.
Making use of concrete materials in cut-off walls, because of their low permeability and standing high Hydraulic Gradient caused by underground drainage, has attracted great amount of attention. Using ordinary concrete with high elasticity modulus, compared to other materials may accompany with problems including brittleness of cutoffs due to dynamic stresses. To solve this problem, adding a ce...
متن کامل