Dynamic mechanical properties of human lenses.
نویسندگان
چکیده
The purpose of this study was to determine the shear compliance of human crystalline lenses as a function of age and frequency. Dynamic mechanical analysis was performed on 39 human lenses, ranging in age from 18 to 90 years, within the frequency range of 0.001-30 Hz. The lenses were stored at -70 degrees C before being measured. The influence of freezing on the mechanical properties was determined using pairs of porcine lenses, with one lens measured directly after enucleation and the other after freezing. The measurement method had a repeatability standard deviation of 4 and 6% for the storage and loss compliance, respectively. The reproducibility standard deviation was 31 and 33% for the storage and loss compliance respectively. On average, freezing increased the storage compliance by 8% and increased the loss compliance by 32%, both depending slightly on age and frequency. The human lenses exhibited a distinct viscoelastic behavior. The storage and loss compliance depended strongly on age and decreased a factor 1000 over a lifetime. Dynamic mechanical analysis has proven to be a successful technique for characterizing the mechanical properties of the human crystalline lens. The shear compliance decreases exponentially with age.
منابع مشابه
Dynamic Simulation and Mechanical Properties of Microtubules
This work is conducted to obtain mechanical properties of microtubule. For this aim, interaction energy in alpha-beta, beta-alpha, alpha-alpha, and beta-beta dimers was calculated using the molecular dynamic simulation. Force-distance diagrams for these dimers were obtained using the relation between potential energy and force. Afterwards, instead of each tubulin, one sphere with 55 KDa weight ...
متن کاملDynamic Mechanical Analysis of Compatibilizer Effect on the Mechanical Properties of Wood Flour-High-Density Polyethylene Composites
In this study, effect of MAPE (maleic anhydride polyethylene) as the compatibilizer on the mechanical properties of wood-flour polyethylene composites has been investigated by using Dynamic Mechanical Analysis (DMA). Composites were made at 25% and 50% by weight fiber contents and 1% and 2% compatibilizer respectively. Controls were also made at the same fiber contents without the compatibilize...
متن کاملThermal Stability and Dynamic Mechanical Properties of Nano and Micron-TiO2 Particles Reinforced Epoxy Composites: Effect of Mixing Method
متن کامل
Investigation of structural, morphological and dynamic mechanical properties of unvulcanized PDMS/silica compound
In this study, the interaction between the silica filler and polydimethylsiloxanes (PDMS) was investigated from the aspects of the bound rubber and morphological characterization. With special attention to the dynamic properties, the dynamic test was conducted by dynamic shear rheometer. The results show that the modified fillers disperse uniformly within PDMS matrix without aggregation and con...
متن کاملIdentification of Dynamic Damping Properties of a Flexible Structural Adhesive
In this paper dynamic damping properties of a nominated flexible structural adhesive have been identified using an extended-direct modal based joint identification method. It has been revealed that damping characteristics of adhesive are correlated to both frequency and mode shape. Young’s and shear moduli increase with frequency but damping on the other hand, decrease. The results showed that ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Experimental eye research
دوره 80 3 شماره
صفحات -
تاریخ انتشار 2005