Behavioural Analysis of Charge-pump Pll’s
نویسندگان
چکیده
This paper presents a method for the numerical analysis of charge-pump Phase-Locked Loops in time domain, using behavioural modelling of non-linear elements. The time domain is divided into intervals according to zero crossing of input and VCO signals. Inside each time interval, all signals in the network can be expressed with a set of functions made of complex polynomials and complex exponentials. A direct solution can be found, without requiring iterative procedures to converge. A computer program implementing the proposed analysis method has been written and applied to secondand third order PLL's.
منابع مشابه
Investigations for Minimum Invasion Digital Only Built-In "Ramp" Based Test Techniques for Charge Pump PLL's
Due to a number of desirable operational and design characteristics, CP-PLL’s (Charge Pump Phase locked loops) have, in recent years become a pervasive PLL architecture. CP-PLL architectures are exploited for a variety of applications such as on chip clock generation, CRC (clock recovery circuits) and Radio frequency synthesis applications. This paper describes a simple, digital only, minimally...
متن کاملContinuous-Time Adaptive Delay System - Circuits and Systems II: Analog and Digital Signal Processing, IEEE Transactions on
We have developed a direction-selective system that has a row of pixels with photodiodes as the front-end. The output of each photodiode is converted to a digital signal, which is then fed to an adaptive-delay block within each pixel. The adaptive block adjusts an internal delay such that the delay matches the phase offset between the rising edges of this digital signal and the corresponding di...
متن کاملAn integral path self-calibration scheme for a 20.1-26.7GHz dual-loop PLL in 32nm SOI CMOS
A bandwidth self-calibration scheme is introduced as part of a 20.1GHz to 26.7GHz, low noise PLL in 32nm CMOS SOI. A dual-loop architecture in combination with an integral path measurement and correction scheme desensitizes the loop transfer function to the VCO’s small signal gain variations. The spread of gain peaking is reduced by self-calibration from 2.4dB to 1dB, when measured at 70 sites ...
متن کاملAnalysis and Design of Charge Pumps for Telecommunication Applications
This chapter addresses modern telecommunication integrated circuits from the synthesizer focal point; in particular it concentrates at the analysis and the design of integrated charge pump circuit blocks. It presents an overview of charge pump topologies in addition to a coherent analysis of the associated benefits and shortcomings of all circuit alternatives. Moreover a novel favorable charge ...
متن کاملUsing an Event-driven Model to Optimise Charge Pump Phase Locked Loops
The design of CP-PLL is a difficult exercise because of the wide range of applications and the complexity of modelling. As shown in [1] a good behavioural model of the second order CP-PLL is the event driven model proposed in [3]. The eventdriven model can run very fast simulations with a good accuracy. In this paper we will define a criterion to measure the quality of a design. This criterion ...
متن کامل