Atomic layer deposition of ZnS nanotubes.
نویسندگان
چکیده
We report on the growth of high-aspect-ratio (approximately > 300) zinc sulfide nanotubes with variable, precisely tunable, wall thicknesses and tube diameters into highly ordered pores of anodic alumina templates by atomic layer deposition (ALD) at temperatures as low as 75 degrees C. Various characterization techniques are employed to gain information on the composition, morphology and crystal structure of the synthesized samples. Besides practical applications, the ALD-grown tubes could be envisaged as model systems for the study of a certain class of size-dependent quantum and classical phenomena.
منابع مشابه
Production and investigation about nano structures of heterogeneous ZnS/glass thin layer
ZnS/glass Thinlayer in high vacuum condition and $40$ degree Deposition angle has been produced by resistance evaporated method with $28$ nm thickness. cabin deposition temperature ZnS layer was about $50C$ and substrates were kept at room temperature. The Atomic Force Microscopy (AFM) and XRD analyses are perfectly accomplished for this layer.
متن کاملHigh-filling-fraction inverted ZnS opals fabricated by atomic layer deposition
The infiltration of three-dimensional opal structures has been investigated by atomic layer deposition. Demonstrations using ZnS:Mn show that filling fractions .95% can be achieved and that the infiltrated material is of high-quality crystalline material as assessed by photoluminescence measurements. These results demonstrate a flexible and practical pathway to attaining high-performance photon...
متن کاملFabrication and Characteristics of Self-Aligned ZnO Nanotube and Nanorod Arrays on Si Substrates by Atomic Layer Deposition
Vertically self-aligned ZnO nanorods and nanotubes are fabricated on Si substrates by atomic layer deposition with the assistance of anodic aluminum oxide at 250°C. These nanostructures are equal in height, isolated, and vertical to the Si substrate. With 550 deposition cycles, we can fabricate regular arrays of ZnO nanorods with an average diameter of 70 nm and with a height of 470 nm. In part...
متن کاملAtomic Layer Deposition of ZnO on Multi-walled Carbon Nanotubes and Its Use for Synthesis of CNT–ZnO Heterostructures
In this article, direct coating of ZnO on PECVD-grown multi-walled carbon nanotubes (MWCNTs) is achieved using atomic layer deposition (ALD). Transmission electron microscopy investigation shows that the deposited ZnO shell is continuous and uniform, in contrast to the previously reported particle morphology. The ZnO layer has a good crystalline quality as indicated by Raman and photoluminescen...
متن کاملHigh Resolution Image with Multi-wall Carbon Nanotube Atomic Force Microscopy Tip (RESEARCH NOTE)
In this paper, a simple and reproducible approach for attaching the multi-wall carbon nanotubes (MWNTs) to the apex of the atomic force microscope probe has been proposed. For this purpose, the dielectrophoresis method was applied due to its simple performance, cheapness and reliability. In this method, various parameters such as voltage, frequency, concentration of carbon nanotubes solution an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Nanotechnology
دوره 20 32 شماره
صفحات -
تاریخ انتشار 2009