Pd/Ga2O3 methanol steam reforming catalysts: Part I: Morphology, composition and structural aspects
نویسندگان
چکیده
The combination of (High-resolution) electron microscopy, Selected Area Diffraction and X-ray Diffraction was applied to study the structural, compositional and morphological alterations of two Pd/Ga2O3 catalysts relevant for methanol steam reforming upon different oxidative and reductive treatments. These systems include well-defined Pd particles grown epitaxially on vacuum-cleaved NaCl(001) single crystals and subsequently covered by a layer of amorphous Ga2O3 (termed as “thin film model catalysts”), as well as, for comparison, a conventional Pd/Ga2O3 powder catalyst prepared by incipient wetness impregnation. Both catalysts were subsequently subjected to similar treatments in O2 (1 bar, 1h) and H2 (1 bar, 1h) in the temperature range between 373 and 923 K. Oxidation of the thin film model catalyst at 773 K converts the Pd/Ga2O3 film into a mixture of PdO and Pd supported on Ga2O3. Subsequent reduction at 523 K causes the formation of an epitaxial Pd5Ga2 bimetallic phase with suppressed Pd hydride formation, in close correlation to the corresponding Pd/ZnO system. In contrast to the latter, Pd/Ga2O3 thin film model catalysts are prone to sintering at reduction temperatures ≥ 673 K. However, Pd5Ga2 with some Pd probably remaining in the particle cores is still present. The stability of the bimetallic Pd5Ga2 phase in oxygen was observed to depend on the prereduction history, that is, oxidation at 673 K of a bimetallic formed at 523 K causes the complete decomposition of the bimetallic phase and formation of PdO/Pd particles supported on Ga2O3, whereas bimetallics formed at higher reduction temperatures (i.e. ≥ 673 K) are only transformed back to Pd/Ga2O3. According to TEM investigations, this is due to the increased mobility of Ga and the subsequent formation of a Ga2O3 surface layer preventing further oxidation to PdO. Reduction of the corresponding Pd/β-Ga2O3 impregnated powder catalyst between 573 and 773 K causes the formation of a Pd2Ga bimetallic phase, which is further converted to PdGa at reduction temperatures of 923 K. No formation of a Ga2O3 surface layer covering the particles has been observed upon reoxidation of the bimetallic. This is explained on the basis of the difference in metal (bimetallic)-support contact area.
منابع مشابه
Pd/Ga2O3 methanol steam reforming catalysts: Part II: Catalytic selectivity
Structure, morphology and composition of two Pd/Ga2O3 methanol steam reforming catalysts were correlated with the associated activity and selectivity changes in the methanol steam reforming reaction and linked to studies on pure Ga2O3 supports. For both systems, that are, a Pd/Ga2O3 thin film model catalyst and a powder-supported Pd catalyst, we identified a temperature range in which the reduc...
متن کاملIn situ Studies of Alloy Formation on a Pd/Ga2O3 Methanol Steam Reforming Catalyst
Methanol steam reforming is a promising reaction in terms of hydrogen production for use in PEM fuel cells. Catalyst research has focused mainly on Cu/ZnO formulations, because of their superior selectivity to CO2 and H2. The common byproduct CO is problematic due to its poisoning effect on the anode of a downstream fuel cell. Some years ago it was shown that palladium supported on certain redu...
متن کاملPdZn/Pd(111) surface alloys as model catalysts for methanol steam reforming
Pd supported on ZnO has recently raised great interest as a catalyst for methanol steam reforming. Different from unsupported Pd, Pd-ZnO shows high selectivity and good conversion towards CO2 and hydrogen [1]. The difference is attributed to the formation of a PdZn alloy under reaction conditions, but there is still limited knowledge on the exact surface structure/composition and reaction mecha...
متن کاملMicro-structured string-reactor for autothermal production of hydrogen
Novel micro-structured string-reactor designed as catalytically active wires placed in parallel into a tube was developed. The small diameter of the channels (∼100 m) leads to a short radial diffusion time, a narrow residence time distribution (RTD), and a low pressure drop. This reactor was applied for the oxidative steam-reforming of methanol (OSRM) to produce hydrogen in autothermal mode for...
متن کاملMethanol Steam Reforming Catalyzing over Cu/Zn/Fe Mixed Oxide Catalysts
Methanol steam reforming plays a pivotal role to produce hydrogen for fuel cell systems in a low temperature range. To accomplish higher methanol conversion and lower CO production, the reaction was catalyzed by CuZnFe mixed oxides. Various ratios of Fe and Cu/Zn were coprecipitated in differential method to optimize the CuZnFe structure. The sample containing 45Cu50Zn5Fe (Wt. %) revealed its m...
متن کامل