Dual-mode Sequential Logic for Function Independent Fault-testing
نویسندگان
چکیده
1 This paper presents a method of using hardware redundancy to ease the problem of fault testing in sequential logic networks. Sequential logic networks are constructed using two kinds of dual-mode logic gates, one of which is specifically required to initialize a feedback loop to some logic value. Initially, it is shown that these networks can be tested for all single stuck-at-faults with six function-independent tests. Next, this method is generalized to detect large classes of multiple faults with six function-independent tests. In both cases, the network must have the proper number of extra inputs.
منابع مشابه
Dual-mode Combinational Logic for Function-independent Fault Testing
This paper presents a method of using hardware redundancy to ease the problem of fault testing in combinational logic networks. Combinational logic networks are constructed using dual-mode logic gates. Initially, it is shown that these networks can be tested for all single stuck-at-faults using just two function-independent tests. This method is then extended to detect a large class of multiple...
متن کاملTestable Sequential Circuits using Conservative Toffoli Gate
Testing of Sequential circuits can be done by two test vectors (all 1’s and all 0’s) if the circuits were based on the conservative logic. The circuit is made to be tested by designing the circuit with the help of Reversible logic gates. Toffoli gate is used as reversible gate in this paper. Sequential circuits such as latches, flip flops are designed with the help of conservative logic reversi...
متن کاملImpact of Partial Reset on Fault Independent Testing and BIST
Partial reset has been shown to have significant impact on deterministic test generation for sequential circuits. In this paper, we explore the use of partial reset in fault-independent testing and application to built-in selftest. We take the following approach: based on fault propagation analysis, we select a subset of the circuit flip-flops to be initialized to 0 or 1. The initialization (se...
متن کاملYaw Rate Control and Actuator Fault Detection and Isolation for a Four Wheel Independent Drive Electric Vehicle
In this paper, a new actuator fault detection and isolation method for a four wheel independent drive electric vehicle is proposed. Also, a controller based on sliding mode control method is proposed for lateral stability of the vehicle. The proposed control method is designed in three high, medium and low levels. At the high-level, the vehicle desired dynamics such as longitudinal speed refere...
متن کاملDiagnostic Test Generation for Transition Delay Faults Using Stuck-At Fault Detection Tools
By adding a few logic gates and one or two modeling flip-flops to the circuit under test (CUT), we create a detection or diagnostic automatic test pattern generation (ATPG) model of transition delay faults usable by a conventional single stuck-at fault test pattern generator. Given a transition delay fault pair, the diagnostic ATPG model can either find an exclusive test or prove the equivalenc...
متن کامل