A 0.18um CMOS Current Reused Low-Noise Amplifier with Gain Compensated for Ultra-Wideband Wireless Receiver
نویسندگان
چکیده
A current reused low-noise amplifier (LNA) with gain compensated to extend the bandwidth and is designed for ultra-wideband (UWB) wireless receiver. The design consists of two cascode common-source amplifier and an output buffer which is implemented in 0.18um RF CMOS process. The LNA gives 13.1dB gain; 9.1GHz 3dB bandwidth (3.1-12.2GHz) while consuming 13.9mW through a 1.8V supply. Over the 3.1GHz 10.6GHz frequency band, a minimum noise figure of 2.7dB and input return loss lower than -8.7dB have been achieved. Index Term – RFIC, Ultra-Wideband, UWB, Gain Compensated, Current Reused, LNA and Low-Noise Amplifier.
منابع مشابه
A High Gain and Forward Body Biastwo-stage Ultra-wideband Low Noise Amplifier with Inductive Feedback in 180 nm CMOS Process
This paper presents a two-stage low-noise ultra-wideband amplifier to obtain high and smooth gain in 180nm CMOS Technology. The proposed structure has two common source stages with inductive feedback. First stage is designed about 3GHz frequency and second stage is designed about 8GHz. In simulation, symmetric inductors of TSMC 0.18um CMOS technology in ADS software is used.Simulations results ...
متن کاملA New Ultra-Wideband Low Noise Amplifier With Continuous Gain Control
This paper presents a new variable gain low noise amplifier (VG-LNA) for ultra-wideband (UWB) applications. The proposed VG-LNA uses a common-source (CS) with a shunt-shunt active feedback as an input stage to realize input matching and partial noise cancelling. An output stage consists of a gain-boosted CS cascode and a gain control circuit that moves the high resonant frequency to higher freq...
متن کاملDesign of Flat Gain and Low Noise Figure LNA for 3.1-10.2GHz Band UWB Applications in 0.18um CMOS Process
This paper shows the design of a broadband low noise amplifier (LNA) for ultra-wideband (UWB) system on 0.18um CMOS process. The proposed LNA uses resistive shunt feedback technique and an inter-stage inductor as an inductive peaking to realize the flat gain throughout the UWB band. The designed UWB LNA has a noise figure lower than 3.5dB, gain above 20dB in the frequency range 3. 1-10.2GHz. It...
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملDesign of 3-16GHz Ultra-Wideband CMOS LNA Based on Current-Reused Topology
This paper presents an UWB low noise amplifier (LNA) based on current reused topology to achieve low power on overall circuit in the band of 3~16GHz. Measurement of the input and output reflection coefficient S11, S22 are less than 10 dB, the maximum amplifier gain S21 gives 9.7dB, the minimum of the noise figure is 4.2dB, the measured IIP3 is 8.5dBm at 6GHz. It consumes 11mW power consumption ...
متن کامل