Surface-related capacitance of microporous carbons in aqueous and organic electrolytes
نویسندگان
چکیده
This paper examines the surface-related capacitance C/S of carbons with average micropore widths between 0.73 and 1.80 nm, using 1-2M H2SO4, 6M KOH and 1M (C2H5)4NBF4 in acetonitrile as electrolytes. Following corrections for pseudocapacitance effects for the aqueous electrolytes and the use of an average surface area suggested by independent techniques, different from the BET area, it appears that C/S is practically independent of the micropore width. The analysis of the data with the help of recent models suggests that the dielectric constants εr of the different electrolytes may decrease with the pore size. It is surprising that the coexistence of two sets of values for the surface area of microporous carbons and its consequence on C/S have not received more attention in the past. 1 Corresponding author. Tel.: +41 32 7182425; Fax: +41 32 7182511. E-mail address: [email protected] (F. Stoeckli)
منابع مشابه
The volumetric capacitance of microporous carbons in organic electrolyte
The study of 26 microporous carbons with average pore widths Lo between 0.7 and 1.8 nm shows that the volume-related capacitance Cmi(F cm) in the organic electrolyte (C2H5)4NBF4/acetonitrile is an inverse function of the average micropore width Lo. This means that for a given micropore volume Wo, the gravimetric capacitance C(F g) is larger for carbons with smaller pores due to the higher surfa...
متن کاملEDLC performance of carbide-derived carbons in aprotic and acidic electrolytes
This study shows that carbide-derived carbons (CDCs) with average pore size distributions around 0.9 to 1 nm and effective surface areas of 1300-1400 m g provide electrochemical double layer capacitors with high performances in both aqueous (2M H2SO4) and aprotic (1M (C2H5)4NBF4) in acetonitrile) electrolytes. In the acidic electrolytic solution, the gravimetric capacitance at low current densi...
متن کاملOptimization of the characterization of porous carbons for supercapacitors
The optimization of carbon-based supercapacitors is of great technological importance for electrical energy storage. This challenge stresses the relevance of current attempts to increase the surface-related capacitance C/S (F m) of carbons. We show that for microporous carbons this property is practically constant for pore widths between 0.7 and 1.8 nm. The study is based on two independent app...
متن کاملN-doped porous carbon capsules with tunable porosity for high-performance supercapacitors
A procedure for the fabrication of N-doped hollow carbon spheres with a high rate capability for supercapacitors has been developed. The approach is based on a nanocasting method and the use of a nitrogen-rich compound (pyrrole) as carbon precursor. The carbon particles thus produced combine a large BET surface area (~1500 m g) with a porosity made up of mesopores of ~ 4 nm and a high nitrogen ...
متن کاملPore size distribution and capacitance in microporous carbons.
Modelling shows that the pore size distribution of microporous carbons determined by NLDFT only hides relatively small variations of the surface-related capacitance C/S between 0.7 and 1.3 nm. This suggests again that C/S in TEABF(4)-AN is 0.09 ± 0.01 F m(-2) for our typical carbons, including carbide-based samples.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2014