Anomalous Heat Produced by Electrolysis of Palladium using a Heavy-Water Electrolyte
نویسنده
چکیده
Significant heat was generated for about 740 min when a sample of palladium foil was electrolyzed as the cathode in D2O+LiOD. A very stable Seebeck calorimeter is described and used to make the measurements. The source of this anomalous energy is unknown. However, the observed energy and production of unexpected elements based on EDX examination are similar to the behaviors claimed by many people who study what is called low energy nuclear reactions.
منابع مشابه
Anomalous Heat Generated by Electrolysis Using a Palladium Cathode and Heavy Water
Samples of palladium sheet supplied by IMRA Japan were tested for anomalous energy production using electrolysis in heavy water and a sensitive calorimeter. Several samples were found to produce significant power above that being applied to produce electrolysis. This behavior was found to correlate with certain properties of the palladium metal. In addition, the anomalous heat was shown to orig...
متن کاملEXCESS HEAT REPRODUCIBILITY AND EVIDENCE OF ANOMALOUS ELEMENTS AFTER ELECTROLYSIS IN Pd|D2O+H2SO4 ELECTROLYTIC CELLS
Electrolyte temperature is a key factor in excess heat production using Pd|D2O+H2SO4 electrolytic cells. Best results are obtained when the electrolyte temperature is close to the boiling point. Stable excess heat is generated by events on or near the Pd cathode surface. In addition to the stable excess heat, heat bursts are sometimes observed. These occurred most frequently in experiments usin...
متن کاملElectrochemical Loading of Hydrogen and Deuterium Into Palladium and Palladium-Boron Alloys
Excess power production and other anomalous effects have been observed during the electrolysis of heavy water using palladium and palladium-boron alloys as the cathode materials. This study focused on hydrogen and deuterium loading into palladium and palladium-boron alloys. Improved calorimetry provided for the detection of the exothermic heat of absorption of deuterium into palladium and palla...
متن کاملMicroanalysis of Palladium after Electrolysis in Heavy Water
The morphology and microcomposition of palladium after electrolysis in heavy water were studied. Fibers which appeared on the surface were observed to change with time. Evidence which supports the possibility of transmutation is presented. INTRODUCTION Previously we reported finding concentrations of unexpected elements on palladium cathodes after electrolysis in an electrolyte containing H2SO4...
متن کاملDeuterium Loading Ratio and Excess Heat Generation during Electrolysis of Heavy Water by a Palladium Cathode in a Closed Cell Using a Partially Immersed Fuel Cell Anode
We have developed a novel electrolytic cell pressurized by D2 in which deuterium loading ratio in a palladium cathode can be determined in-situ during the calorimetric measurements of excess heat. A gas diffusion type fuel cell anode is partially immersed in the electrolyte solution to act as a counter electrode, at which electrochemical oxidation of deuterium gas molecules to deuterium ions ta...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2007