Fabrication and investigation of the optoelectrical properties of MoS2/CdS heterojunction solar cells
نویسندگان
چکیده
Molybdenum disulfide (MoS2)/cadmium sulfide (CdS) heterojunction solar cells were successfully synthesized via chemical bath deposition (CBD) and chemical vapor deposition (CVD). The as-grown CdS film on a fluorine tin oxide (FTO) substrate deposited by CBD is continuous and compact. The MoS2 film deposited by CVD is homogeneous and continuous, with a uniform color and a thickness of approximately 10 nm. The optical absorption range of the MoS2/CdS heterojunction covers the visible and near-infrared spectral regions of 350 to 800 nm, which is beneficial for the improvement of solar cell efficiency. Moreover, the MoS2/CdS solar cell exhibits good current-voltage (I-V) characteristics and pronounced photovoltaic behavior, with an open-circuit voltage of 0.66 V and a short-circuit current density of 0.227 × 10(-6) A/cm(2), comparable to the results obtained from other MoS2-based solar cells. This research is critical to investigate more efficient and stable solar cells based on graphene-like materials in the future.
منابع مشابه
Preparation of CdIn2S4-CdS nanocomposite via a green route and using them in dot-sensitized solar cells for boosting efficiency
In this work In2S3 and CdS nanoparticles were prepared by a simple hydrothermal method and then annealed at 500 °C for 2 h in an Ar gas until CdIn2S4(CdIS)-CdS nanocomposites were formed. Afterwards, efficiency of the as-synthesized CdIS-CdS nanocomposite in quantum dot-sensitized solar cells (QDSSCs) was evaluated. For this purpose, the as-prepared CdIS-CdS nanocomposites were deposited on TiO...
متن کاملInvestigations on structural and electrical properties of Cadmium Zinc Sulfide thin films
Nowadays, II – IV group semiconductor thin films have attracted considerable attention from the research community because of their wide range of application in the fabrication of solar cells and other opto-electronic devices. Cadmium zinc sulfide (Zn-CdS) thin films were grown by chemical bath deposition (CBD) technique. X-ray diffraction (XRD) is used to analyze the structure and crystallite ...
متن کاملInvestigations on structural and electrical properties of Cadmium Zinc Sulfide thin films
Nowadays, II – IV group semiconductor thin films have attracted considerable attention from the research community because of their wide range of application in the fabrication of solar cells and other opto-electronic devices. Cadmium zinc sulfide (Zn-CdS) thin films were grown by chemical bath deposition (CBD) technique. X-ray diffraction (XRD) is used to analyze the structure and crystallite ...
متن کاملFabrication of single-layer MS2 (M=Mo, W) nanosheets using Li battery setup
Lithium intercalation is a convenient method to prepare few-layer and single-layer MS2 (M=Mo, W) nanosheets. This method is, however, very time-consuming (few days) and it is difficult to control the reaction parameters. To overcome these drawbacks, we have proposed a method to use an Li battery set-up to significantly reduce the reaction time (few hours) and electrochemically intercalate lithi...
متن کاملInvestigation of Physical Properties of e-Beam Evaporated CdTe Thin Films for Photovoltaic Application
CdTe thin films with 2.8 µm thickness were deposited by electron beam evaporation method. X-ray diffraction, scanning electron microscopy, UV-Vis-NIR spectroscopy and atomic force microscopy (AFM) were used to characterize the films. The results of AFM analysis revealed that the CdTe films have uniform surface. CdTe thin films were heat-treated by SnCl2 solution. Structural analysis using XRD s...
متن کامل