Optimization of Process Parameters in Wire Electrical Discharge Machining of Inconel X-750 for Dimensional Deviation Using Taguchi Technique
ثبت نشده
چکیده
منابع مشابه
Multi-objective optimization in WEDM of D3 tool steel using integrated approach of Taguchi method & Grey relational analysis
In this paper, wire electrical discharge machining of D3 tool steel is studied. Influence of pulse-on time, pulse-off time, peak current and wire speed are investigated for MRR, dimensional deviation, gap current and machining time, during intricate machining of D3 tool steel. Taguchi method is used for single characteristics optimization and to optimize all four process parameters simultaneous...
متن کاملOptimization of Process Parameters of Wire Electrical Discharge Machining Using Fuzzy logic Integrated with Taguchi Method
In this paper, fuzzy logic integrated with the Taguchi method is used to optimize Wire Electro Discharge Machining (WEDM) process with multiple quality characteristics. Rough machining with EDM gives poor surface finish and has micro cracks and pores. Finish machining gives better surface finish but with very poor machining speed (MRR). Spark gap width is one of the important performance measur...
متن کاملOptimization of Process Parameter of Wire Electrical Discharge Machine by Response Surface Methodology on Inconel-600
in the present paper, the study has been made to optimize the process parameters during machining of Inconnel-600 by wire electrical discharge machining (WEDM) using response surface methodology (RSM). Four input process parameters of WEDM (namely Peak Current (IP), Pulse-On time (TON), Pulse-Off time (TOFF) and Wire Feed rate (WF)) were chosen as variables to study the process performance in t...
متن کاملAn empirical study on statistical analysis and optimization of EDM process parameters for inconel 718 super alloy using D-optimal approach and genetic algorithm
Among the several non-conventional processes, electrical discharge machining (EDM) is the most widely and successfully applied for the machining of conductive parts. In this technique, the tool has no mechanical contact with the work piece and also the hardness of work piece has no effect on the machining pace. Hence, this technique could be employed to machine hard materials such as super allo...
متن کاملIntelligent Knowledge Based System Approach for Optimization of Design and Manufacturing Process for Wire-Electrical Discharge Machining
Wire electrical discharge machining (WEDM) is a method to cut conductive materials with a thin electrode that follows a programmed path. The electrode is a thin wire. Typical diameters range from .004" - .012" (.10mm - .30mm) although smaller and larger diameters are available. WEDM is a thermal machining process capable of accurately machining parts with varying hardness or complex shapes. WED...
متن کامل