The effect of pre-cooling intensity on cooling efficiency and exercise performance.
نویسندگان
چکیده
Although pre-cooling is known to enhance exercise performance, the optimal cooling intensity is unknown. We hypothesized that mild cooling opposed to strong cooling circumvents skin vasoconstriction and thermogenesis, and thus improves cooling efficiency reflected in improved time to exhaustion. Eight males undertook three randomized trials, consisting of a pre-cooling and an exercise session. During the pre-cooling, performed in a room of 24.6 +/- 0.4 degrees C and 24 +/- 6% relative humidity, participants received either 45 min of mild cooling using an evaporative cooling shirt or strong cooling using an ice-vest. A no-cooling condition was added as a control. Subsequent cycling exercise was performed at 65%[Vdot]O(2peak) in a climatic chamber of 29.3 +/- 0.2 degrees C and 80 +/- 3% relative humidity. During the pre-cooling session, mild and strong cooling decreased the skin blood flow compared with the control. However, no differences were observed between mild and strong cooling. No thermogenesis was observed in any conditions investigated. The reduction of body heat content after pre-cooling was two times larger with strong cooling (39.5 +/- 8.4 W . m(-2)) than mild cooling (21.2 +/- 5.1 W . m(-2)). This resulted in the greatest improvement in time to exhaustion with strong cooling. We conclude that the cooling intensities investigated had a similar effect on cooling efficiency (vasoconstriction and thermogenesis) and that the improved performance after strong cooling is attributable to the greater decrease in body heat content.
منابع مشابه
طراحی و ساخت جلیقه خنککننده از مواد تغییر فاز دهنده و ارزیابی کارایی آن در کاهش استرین گرمایی تحت شرایط آزمایشگاهی
Introduction: Water and paraffin are well-known phase change materials used in the manufacturing of cooling vests. The present study was conducted to design and make a cooling vest using commercial paraffin compounds and ice and to then examine their effect on thermal strain parameters in hot climate conditions in a climate chamber. Materials and Methods: A cooling vest was first made with p...
متن کاملPassive Energy Air-to-Water Heat Pipe Based Heat Exchanger and its Potential of Air Pre-cooling in Air Conditioning Systems for Iran Climate
Air pre-cooling equipment is normally being employed in air-conditioning systems for pre-cooling the ambient outdoor air to enhance the air-conditioning systems performance. In this study, the potential of a passive water-to-air heat pipe based heat exchanger (HPHEX) for air pre-cooling purpose in air-conditioning systems for the high cooling load demanding regions of Iran was investigated. To ...
متن کاملStudy of Degradation of Dry Cooling Tower Performance under Wind Conditions and Method for Tower Efficiency Enhancement (RESEARCH NOTE)
Wind affects adversely the cooling tower thermal performance. A field investigation was carried out to study the thermal performance of Heller cooling towers under wind conditions, involving measurement of wind velocity and its direction around the cooling tower, and obtaining water flow rates and temperatures at the cooling tower inlet and outlet. Results show that air suction at the tower top...
متن کاملEffect of Wind on Thermal Performance of Heller Dry Cooling Tower
In a steam power plant, the temperature of the cooling water leaving the condenser for recyclingshould decrease. This is achieved in a cooling tower. The Heller cooling tower does not require waterfor operation, thus, it is a suitable system for use in thermal power plants throughout Iran. Wind is anenvironmental factor that unfavorably affects the performance of a cooling tower. Previous studi...
متن کاملDesign and construction of evaporative local cooling coatings and evaluate their efficiency in improving some perceptual indicators in laboratory conditions
Introduction: One way to reduce the level of heat strain is to use personal evaporative cooling coats. such as the wrist, ankle, head and neck. The purpose of this study is to design, construct, and determine the cooling power of local cooling coatings and evaluate their efficiency in improving perceptual indicators in the laboratory. Materials and Methods: Initially, the design and constructio...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید
ثبت ناماگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید
ورودعنوان ژورنال:
- Journal of sports sciences
دوره 28 7 شماره
صفحات -
تاریخ انتشار 2010